Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Hive Manuals
  4. DJ Equipment
  5. KILLER Plasma Maxi
  6. Operating instructions manual

Hive KILLER Plasma Maxi Operating Instructions Manual

Two-light
Hide thumbs

Advertisement

Quick Links

Download this manual

Advertisement

loading
Need help?

Need help?

Do you have a question about the KILLER Plasma Maxi and is the answer not in the manual?

Questions and answers

Summary of Contents for Hive KILLER Plasma Maxi

  • Page 2 TABLE OF CONTETS: Product Overview Pg. 3 General Instructions Pg. 4 RE-Strike Pg. 5 DMX Operation Pg. 6 Four-Light Frame Pg. 8 Safety Instructions Pg. 9 Warranty and Technical Assistance Pg. 10...

  • Page 3: Product Overview

    Thank you for purchasing Hive Lighting’s KILLER Plasma Two- Light Maxi fixture. The KILLER Maxi represents a re-imagination of the traditional par array. Inspired by classic cinema lamps, like the Maxi-Brute and Dino, Hive’s KILLER Two – Light Maxi fixture marries Hive’s Plasma Par™...

  • Page 4: General Instructions

    GENERAL INSTRUCTIONS: OPERATION (AC POWER) - Check to make sure the inline switch is in the OFF position. - Plug NEMA 15A U – Ground AC plug into a source of AC power. - Flip inline switch into ON position. - Make sure both individual bulb switches are in the ON position.
  • Page 5 RE-STRIKE “HOT” RE-STRIKE: Hive Lighting’s KILLER Plasma Maxi has an initial strike time of 30 – 90 seconds. If the KILLER Plasma Maxi has been running for over 30 minutes and the lamp is turned OFF it is best to wait 30 – 60 seconds before turning the lamp back on.
  • Page 6 DMX OPERATION DMX512 : Upon power-up, the interface will display the software version number for two seconds. It will then display the current DMX address. The interface will always default to remote DMX mode upon power up. The DMX address is held in non-volatile memory and will be recalled upon power up.
  • Page 7 “LO” (STANDBY MODE) / ON-OFF CONTROL (VIA DMX BOARD) - The DMX to Hive lamp interface uses a single DMX channel. When the channel is in the range of 0-30 percent the DMX signal will turn the lamp “Off”. When the DMX channel is in the range of 31-60 percent, the lamp will go to standby.
  • Page 8 KILLER mounting point. FOUR – LIGHT MAXI SPACELIGHT: The KILLER Plasma Maxi can be used in any orientation and be hung from a lighting grid or stand. When KILLER Plasma Maxi is being used in the Four-Light Maxi Frame it will fit inside a traditional 6,000W Tungsten spacelight silk and skirt.

  • Page 9: Important Safety Instructions

    - Allow space for proper ventilation around fixture. - Do not operate if there is any damage to cables, plugs or fixture. - The mounting accessories provided by HIVE are only intended for lamp placement/positioning; user must affix an approved safety cable (or other approved safety device) on all lamps at all times.
  • Page 10 TECHNICAL AND WARRANTY ASSISTANCE: For all questions about Hive Lighting’s Killer Plasma Maxi that are not answered in this manual, or require warranty assistance, contact the local dealer of Hive Lighting’s Plasma Fixtures or Hive Lighting’s Technical Support. Hive Lighting Inc.