Advertisement

Operator's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Electro Jac 6 and is the answer not in the manual?

Questions and answers

Summary of Contents for Neogen Corporation Electro Jac 6

  • Page 1 Operator’s Manual...
  • Page 3: Table Of Contents

    Table of contents Usage suggestions for ElectroJac 6 ............2 Precautions .....................3 Standard ElectroJac 6 components ............4 ElectroJac 6 optional accessories ............4 Electronics instrument case ..............5 Automatic operation with wireless remote control ........6 Automatic operation with optional dwell cable ..........7 Manual operation with wireless remote control .........8 Manual operation with optional dwell cable ..........9 Troubleshooting ..................10 Frequently asked questions ..............11...
  • Page 4: Usage Suggestions For Electrojac 6

    Usage suggestions for ElectroJac 6 Immobilize the bull Use a head gate and squeeze chute, or similar solid enclosure, to limit the side-to-side and forward and backward motion of the bull. Bulls with room to move are more likely to fall, making collections more difficult. Footing is critical Providing secure footing is perhaps the most important aspect of preparing a bull for collection.
  • Page 5: Precautions

    Precautions Make sure the battery is connected properly. If the battery leads are reversed, the charging circuit can be permanently damaged. Do not lay the probe on anything metallic when it is connected to the electronics. Do- ing so could short out the electrodes and may blow the fuse. Keep electronics away from water.
  • Page 6: Standard Electrojac 6 Components

    Standard ElectroJac 6 components 6915 – Remote control Electronics instrument case 6903 – AC battery charger 6912 – 20’ Probe cable 6986 – Metric scrotal 6983 – Semen collection assembly tape director cone 6984 – Semen collection vial 6985 – Semen collection handle assembly And your choice of probe size: 6906-1 –...
  • Page 7: Electronics Instrument Case

    Electronics instrument case The electronics instrument case contains the system’s electronics. This state-of-the-art design includes the following features: Automatic operation Manual operation In automatic mode, the circuit delivers a In manual mode, the intensity is con- series of 40 cycles, with each cycle deliver- trolled by adjusting the manual control.
  • Page 8: Automatic Operation With Wireless Remote Control

    Automatic operation with wireless remote control To protect the unit and the animal, ElectroJac 6 must be prepared for use prior to beginning the operation. To prepare the unit: a. Set the Auto/manual switch on the electronics instrument case to Auto. b.
  • Page 9: Automatic Operation With Optional Dwell Cable

    Automatic operation with optional dwell cable NOTE: Optional accessory (not included in the complete set) To protect the unit and the animal, ElectroJac 6 must be prepared for use prior to beginning the operation. To prepare the unit: Set the Auto/manual switch on the electronics instrument case to Auto. Set the On/off switch on the dwell control box to Off.
  • Page 10: Manual Operation With Wireless Remote Control

    Manual operation with wireless remote control Preparation Neogen recommends operators familiarize themselves with the operation of the manual control prior to using ElectroJac 6’s manual setting. To accomplish this, do the following: Set the Auto/manual switch on the electronics instrument case to Manual. Set the Manual control on the electronics instrument case to Low.
  • Page 11: Manual Operation With Optional Dwell Cable

    Manual operation with optional dwell cable NOTE: Optional accessory (not included in the complete set) Preparation Neogen recommends operators familiarize themselves with the operation of the manual control prior to using ElectroJac 6’s manual setting. To accomplish this, do the following: Connect only the dwell cable to the electronics instrument case.
  • Page 12: Troubleshooting

    Troubleshooting What do I do if my remote control does not turn on the unit? Replace the battery (size CR 2032). To get to the battery, remove the screw on the back of the remote control. What do I do if my battery will not charge? Look at the low battery light: if it flashes red, the battery is low.
  • Page 13: Frequently Asked Questions

    Frequently asked questions What are the advantages of ElectroJac 6 over other units? ElectroJac 6 is a fully portable ejaculation unit that will operate manually or automati- cally through 40 increasing power output cycles. With proper use of the dwell switch, semen collection is made easier, especially from older bulls that may be difficult to stimulate.
  • Page 14: Battery And Ac Battery Charger

    Battery and AC battery charger A 12-volt gel cell battery and AC battery charger are supplied with ElectroJac 6. To ensure optimum power performance from the unit: Always start with a fully-charged battery. ElectroJac 6 can be left plugged in indefinitely after each use. The electronics ensure that the battery is not damaged due to overcharging.
  • Page 15: Fuse Replacement

    ElectroJac 6’s fuse is located above the battery in the battery compart- ment. Authorized repair center Neogen Corporation Attn: Electronics Department 944 Nandino Blvd. Lexington, KY 40511 800/525-2022 or 859/254-1221 IMPORTANT: Always check the unit for shipping damage immediately after receipt from repair.
  • Page 16 800/621-8829 or 859/254-1221 www.neogen.com ©Neogen Corporation, 2012. Ideal and ElectroJac are registered trademarks of Neogen Corporation, Lansing, MI 48912. L2429-0112...

Table of Contents