Advertisement
Advertisement
Summary of Contents for Patrick Industries PD3216W
- Page 1 32 INELECTRICFIREPLACE MODEL SF103 35 MODEL PD3216W...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Safety Information............3 Preparation..............4 Preparation Installation)..........5 Operating Instruction............6 Care and Maintenance............7 Troubleshooting.............8 Rev 0 3 10... -
Page 3: Safety Information
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble , operate or install the product. Any use of this appliance other than that recommended by the manufacturer in this owners manual may cause fire, burns, electric shock and/or other serious injuries or death. When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock and injury to persons including the following: Read the manufacturers instructions completely before using this appliance. -
Page 4: Preparation
PREPARATION CAUTION: This heater has front panel made of GLASS Always use extreme caution when handling glass Failure to do so could result in personal injury or personal damage . ). This heater is for use on 120 Volts The heater has a 3 prong grounded plug Figure 2 A If your . - Page 5 PREPARATION Installation: Please assemble on soft and clean surface to prevent damage or scratch. Fastening the Hinges Installing the Fireplace Fasten the mounting hinges with 4pcs of 4x8mm screws Secure the fireplace to the wall using Anchor Screws 6x25mm Secure the hinges with Anchor Screws 6x25mm Hanging the Front Frame Hang the Front Frame on the fireplace and gently push on the lower part of the frame Until it snaps into place...
-
Page 6: Operating Instruction
OPERATING INSTRUCTION Read all instructions and warning prior to operating the appliance.Ensure that all controls are in the “OFF” position before plugging the appliance in to a properly grounded electrical outlet. Flame and heater can be presenting separately or at the same time. TheFireplacecontrolfunctionscanbeaccessedintwoways Using the touchpad control panel located on the upper right hand of the fireplace Figure 4 Using the multi function remote control Figure 5... -
Page 7: Care And Maintenance
CARE AND MAINTENANCE WARNING: Before attempting to perform any maintenance on this unit turn all controls to " " position and unplug A least 10 minutes before any llow the unit to be " " for at maintenance applied in order to allow all components to cool down properly. Cleaning: To remove dust fingerprints or other marks from glass window use clean damp cloth Do not spray glass cleaner or other liquids directly onto the glass. -
Page 8: Troubleshooting
Trouble Shooting WARNING: Turn off the unit unplug and allow the unit to cool for at least 10 minutes before attempting to perform any service Only a qualified professional should attempt to service or repair the unit. PROBLEM POSSIBLE CAUSE SOLUTION Simulated flame is 3.