ClearCube Zero Client Quick Start Manual

Zero Client DVD Player Bundle Quick Start Guide
About the DVD
Player Bundle
Zero Client
DVD Player
Supplying
Power
Opening and
Closing
ClearCube Technology, Inc.
The Zero Client DVD Player Bundle includes a DVD player (reader/writer) and a ClearCube zero
client. Use the player to read and write DVDs and CDs when connected to a remote blade or VM.
Your zero client might look different than the one shown below.
The DVD player is powered by a zero client USB port. As shown in the picture below, use the
included USB-to-mini-USB cable to connect the DVD player to the zero client. Your zero client
might look different than the one shown below.
Zero Client
USB Port
To open: Press the Open button (shown above) on the front of DVD tray.
NOTE: To open the DVD player, the zero client must establish a PCoIP session with a remote host
(such as a blade or VM). When a PCoIP session is established, the zero client power button
is green, and the PCoIP session indicator is green. After a session is established with a
remote host, the zero client USB ports enumerate and the DVD player can open. See the
included zero client Quick Start Guide for information about establishing a PCoIP session.
The DVD tray does not open when the zero client is in standby mode (indicated by an
orange power button).
To close: Push the tray inward until it locks in place.
Manual eject: If the DVD tray does not open after pressing the button, gently insert a thin object
(such as a straightened paper clip) into the manual eject opening. This operation releases the tray.
3700 W Parmer Lane
Open Button
Page 1 of 2
Austin, TX 78727
PCoIP Session
Indicator
Zero Client
Power Button
Manual Eject
Continued on next page
P/N G0200174 Rev A, 1.0.10.09.2015
(512) 652-3500 www.clearcube.com
Mini USB
Port