Fcc Certification - HID pivCLASS R10-H Installation Manual

Table of Contents

Advertisement

I N STALLATI ON GU ID E
C
Credential Presentation Best Practices
To ensure a successful read of a PIV card:
1. Hold card between the thumb and index finger.
2. Present the card so that the index finger creates a spacing between the card and the reader face.
Do not place the card flat on the reader.
3. Place the card parallel to the reader form factor. Do not angle to the right or left
4. Place the card parallel to the reader face. Do not angle the card up or down from the reader
face.
UL
Connect only to a Listed Access Control / Burglary power-limited power supply. These readers are intended to be used with listed (UL294) control
equipment.
All models are suitable for outdoor use.
Evaluated for use over Wiegand and RS-485 communications.
Evaluated for use with the M2000 pivCLASS Authentication Module as well as Standard Wiegand and OSDP panels.
FCC C
ertiFiCation
CAUTION: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this
equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
HID Global
Americas & Corporate
611 Center Ridge Drive
Austin, TX 78758
USA
Support: 866 607 7339
Fax:
949 732 2120
For additional offices around the world, see www.hidglobal.com corporate offices.
HID Global Customer Support: www.hidglobal.com/customer-service
h id g l o b al .co m
pivCLASS
Asia Pacific
19/F 625 King's Road
North Point, Island East
Hong Kong
Support: 852 3160 9833
Fax:
852 3160 4809
Equipment
8T29
ACC Control Reader
An ASSA ABLOY Group brand
R10-H, RP10-H, R40-H, RP40-H, RK40-H, RPK40-H, RKCL40-P,
Europe, Middle East & Africa
Phoenix Road
Haverhill, Suffolk CB9 7AE
England
Support: 44 (0) 1440 711 822
Fax:
44 (0) 1440 714 840
General Signaling
Equipment
RPKCL40-P, RKCLB40-P

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pivclass rp10-hPivclass r40-hPivclass rp40-hPivclass rk40-hPivclass rkcl40-pPivclass rpk40-h ... Show all

Table of Contents