Table of Contents
Advertisement
INSTALLATION NOTES
SYSTEM RULES
These two rules will help you understand what is possible with this product:
Rule 1: This product uses 10 channels. Each transmitter needs to use a different channel,
therefore you can have up to 10 transmitters in the same WiFi environment.
Rule 2: Only 2 receivers at most can be linked to a transmitter.
DISPLAY SLEEP
The Rx will stop outputting HDMI if no source is present for 10 minutes. This allows the display
to go to sleep when the source is off.
SWITCH TIME
Can be up to 7 seconds because an EDID has to happen each time.
FREQUENCY SPECTRUM
This product uses 5GHz WIFI channels so it can be affected by outside interference in the same
way as any wifi device. This product uses non-DFS channels.
IR PASSBACK
If using a source device which has a remote control, this product allows the remote to be
pointed at the display in the remote location. The IR signal is relayed from the Rx to the Tx to
the source device.
To make this happen the IR blaster and receiver cables mush be used.
The diode on the blaster must be as close as possible to the source IR receiver.
•
•
The diode on the receiver must be in line-of-sight of the remote control.
TC-HDMIWM_manual_en.doc
8
Advertisement
Table of Contents
