1. Manuals
  2. Brands
  3. Make Noise Manuals
  4. Network Router
  5. Rosie
  6. Manual

Make Noise Rosie Manual

Electronic signal router
Hide thumbs Also See for Rosie:

Advertisement

Table of Contents

See also: Manual
Rosie

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Rosie and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Make Noise Rosie

Summary of Contents for Make Noise Rosie

  • Page 1 Rosie...
  • Page 2 Malfunction resulting from wrong power supply voltages, backwards power cable connection, abuse of the product or any other causes determined by Make Noise to be the fault of the user are not covered by this warranty, and normal service rates will apply.
  • Page 3 RED stripe on the cable is oriented to the NEGATIVE 12 volt supply line. On the Make Noise power bus board, the negative 12 volt supply is indicated by the white stripe.
  • Page 4 Rosie Panel Connections Channel A Signal Input: expects typical 10Vpp Audio signal from Modular System. AC coupled. Channel B Signal Input: expects typical 10Vpp Audio signal from Modular System. AC coupled. Channel A Level Indicator: LED lights to show strength of signal patched to Channel A input.
  • Page 5 Additonally it allows for stereo processing of all sounds that are live in the PA using the the FX Loop. The Rosie is also suitable for headphone monitoring of the modular system for personal use and for interfacing the modular system to a recording environment.
  • Page 6 OUT on the Rosie. The Return Level on the Rosie will set the amount of processed signal that is blended in with the dry/ unprocessed signal. The Master Level control will set the overall volume of the signal at the Master Line OUT.
  • Page 7 The Line Output The LINE out level is clean up to about 75%, where it will start to overload and clip. The OVL (overload) indicator will light to indicate this clipping. The LINE Out is a Tip Ring Sleeve jack the provides a Stereo output on a single jack.
  • Page 8 Ping Pong Reverb Patch audio of your choice to either or both of the Rosie inputs. Patch SEND to Erbe-Verb IN. Set Erbe-Verb MIX to 100% wet. Patch Erbe-Verb Left OUT to Optomix Ch1 Signal IN, and Erbe-Verb Right OUT to Optomix Ch2 Signal IN.

Table of Contents