Before you Begin Congratulations on the purchase of your Tiger Chipper Shredder Model CS7-200H or CS7-270H The Tiger Chipper Shredder is proudly NZ made, designed to chip and shred your garden waste into fine mulch to use back in your garden as rich compost. Improve the health of your soil and plants; retain moisture and reduce weeds.
Tighten hex bolts at bottom to stop chute from rattling and tighten lock nuts. Remove main chipper body, wheel and axle from box. Fasten axle to chipper body using fasteners supplied in axle shaft. Tiger Chipper Shredder CS7-200H & CS7-270H Owners Manual (PART CS-M) page 4...
Before inspecting or servicing any part of the machine, shut off the power source, disconnect the spark plug wire from the spark plug, and make sure that all moving parts have come to a complete stop. Tiger Chipper Shredder CS7-200H & CS7-270H Owners Manual (PART CS-M) page 5...
If the cutting mechanism strikes any foreign objects or if the machine should start making any unusual noise or vibration, immediately shut off the engine and allow the machine to stop. Disconnect the spark plug wire from the Tiger Chipper Shredder CS7-200H & CS7-270H Owners Manual (PART CS-M) page 6...
Page 7
The maximum capacity is 70mm diameter branches. Depending on the type and hardness of wood, you need to limit the material to smaller lengths. Paper and cardboard can be processed. A better result is obtained if the material is wet prior to processing. Tiger Chipper Shredder CS7-200H & CS7-270H Owners Manual (PART CS-M) page 7...
The chipper blades should be sharpened on a surface grinder or replaced with new ones. Make sure there is plenty of coolant used when grinding, to avoid softening of the material. The cutting angle is critical for the performance of Tiger Chipper Shredder CS7-200H & CS7-270H Owners Manual (PART CS-M) page 8...
Too much clearance will allow small twigs and fibrous materials to be dragged through without being cut. Plan View: Rotor & Shredder Knife Setup Side View: Rotor & Shredder Knife Setup Tiger Chipper Shredder CS7-200H & CS7-270H Owners Manual (PART CS-M) page 9...
CS7-200H & CS7-270H Blade & Anvil Diagrams Side View: Blade & Anvil Set Up Top View: Blade & Anvil Set Up 3D View: Blade & Anvil Set Up Tiger Chipper Shredder CS7-200H & CS7-270H Owners Manual (PART CS-M) page 12...
CS7-200H & CS7-270H Belt Tension & Replacement 3D View: Belt Tension Front View: Belt Tension 3D View: Belt Replacement Tiger Chipper Shredder CS7-200H & CS7-270H Owners Manual (PART CS-M) page 13...
Page 14
Remove 4 hex bolts and nyloc nuts to remove the Honda GX 270 Engine Once engine is unscrewed the pulley belts will be loose and be able to be removed Tiger Chipper Shredder CS7-200H & CS7-270H Owners Manual (PART CS-M) page 14...
Page 15
Assembled Pulley System: CS7-200H Assembled Pulley System: CS7-270H Diagrams shows correct pulley assembly for both Tiger Chipper Shredder Models NOTE: Engine not shown for viewing of the pulleys. Tiger Chipper Shredder CS7-200H & CS7-270H Owners Manual (PART CS-M)
To take advantage of the Tiger Limited Warranty you must have maintenance performed per the schedule contained in the Owner’s Manual supplied with this product by an authorised Tiger Dealer. To ensure the safe operation of this product, we strongly recommend that you only use an authorised Tiger Dealer for servicing. The cost of routine or required maintenance and services is the responsibility of the purchaser.
Limitations • Tiger Chipper Shredder reserves the right to modify, alter and improve any product without incurring any obligation to replace any product previously sold with such modification. • Equipment and accessories not manufactured by SOPE (such as engine, battery and tyres), are warranted only to the extent of the original manufacture’s warranty and subject to their allowance to SOPE only if...
Explain the maintenance requirements and the importance of following the maintenance schedule to the owner/operator. Manual Emphasise the importance of reading and understanding the manual in full before initial operation of the Tiger Chipper Shredder. Tiger Chipper Shredder CS7-200H & CS7-270H Owners Manual (PART CS-M) page 18...
Need help?
Do you have a question about the CS7-200H and is the answer not in the manual?
Questions and answers