BC Design SABRE EAK025 Installation Instructions

Please read these instructions carefully before installation.
SABRE
Installation should be carried out by a Part P qualified electrician.
GENERAL
THIS PRODUCT MUST BE EARTHED. IF THERE ARE ONLY TWO WIRES COMING FROM YOUR POWER
SUPPLY IT MEANS THAT THIS FITTING BE WIRED TO AN UNEARTHED CIRCUIT. CONTACT A QUALIFIED
ELECTRICIAN TO INSTALL A SUITABLE EARTH FACILITY.
ENSURE ELECTRICITY IS SWITCHED OFF AT THE MAINS BEFORE INSTALLING OF MAINTAINING ANY
ELECTRICAL PRODUCT.
THIS PRODUCT IS FOR INDOOR USE ONLY.
THIS PRODUCT IS IP44 RATED AND SHOULD BE INSTALLED ONLY IN ZONES 2 & 3 OF THE BATHROOM
AS DEFINED BY THE IEE WIRING REGULATIONS (SEE DIAGRAM BELOW)
REPLACE FAILED LAMPS IMMEDIATELY. ALLOW THE GLASS, LAMP AND FITTING TO COOL BEFORE
REPLACING THE LAMP.
c/w Wave-on Sensor Switch
EAK025
IMPORTANT
When working at heights, please use a suitable platform to work from.
Please note: For new installations, check for any electrical cables or pipe
work (gas/water) in the vicinity of the intended mounting point before proceeding
with the installation.
Ensure that the fixing location is able to take the weight of the complete fitting.
Wear suitable eye protection when drilling. Be careful when using power tools near water.
EAK030
150mm
ILLUMINATED CABINET INSTALLATION INSTRUCTIONS
IEE Bathroom Zones Diagram
60CM
zone
zone
1
2
60CM
RADIUS
zone
2
OUTSIDE ZONES
The product must be installed with a
minimum distance of 150mm between
the infrared sensor and an adjacent
countertop or obstruction to ensure correct
function of the sensor(see diagram left)
we may place sensors in different positions
depending on product (they are not changeable)
MIN
150mm
MIN
BC Designs Tel: 01206 827100 website@ www.bcdesigns.co.uk email:sales@bcdesigns.co.uk
60CM
zone
2
225cm
Do NOT strike mirror glass with hard or pointed items. It is
recommended that the product is cleaned with a soft, dry,
non abrasive cloth. Do NOT use cleaning agents or abrasive
materials on any type of finished surface. Do NOT allow
moisture to come into contact with the electrical components.
Compliance
This product complies with the following safety standards:
BS EN 60598-1: 2008+A11: 2009, EN60598-2-1: 1989
Wiring
This product is manufactured to class I category and requires
an earth connection
COLOUR CODING:
L - Live = Brown
N - Neutral = Blue
- Earth = Green & Yellow
REPLACEMENT OF LED STRIPS
WARNING - turn off at consumer unit or fuse board before accessing wiring.
When replacing an LED strip please follow the steps illustrated below.
1. 2.
● IN THE EVENT THAT ANY PROBLEMS ARE EXPERIENCED WITH THIS
PRODUCT PLEASE REFER TO YOUR SUPPLIER BEFORE ATTEMPTING ANY
REPAIR. OTHERWISE GUARANTEES & WARRANTIES MAY BE VOID.