Advertisement
Ø8 mm
Ph2
Installation procedure
1.Open the carton and make sure all the parts listed below are present
3x
7x
7x
2x
1x
12x
1x
8x
2.Mark a desired height of the mirror and draw a horizontal line on the wall which corresponds with the
height of the cabinet hangers. Drill the required holes and insert the wall plugs. Note: Wall plugs provided
are suitable for Stone or Brick walls. For other wall types use appropriate wall plugs. If in doubt consult an
expert.Then screw the brackets to the all using the screws provided. Please ensure the screws are fully
tight.
BC Designs Tel: 01206 827100 website@ www.bcdesigns.co.uk email:sales@bcdesigns.co.uk
ILLUMINATED CABINET INSTALLATION INSTRUCTIONS
FLOOR
FROM
HEIGHT
DESIRED
CHOOSE
3.Make the electrical connections, make sure to turn o ffthe electrical supply at the mains. Connection must be made in
accordance with the latest IEE regulations. This cabinet is manufactured to Class I and requires an earth connection.
4.Hang the cabinet on the wall bracket. The claws on the cabinet hangers must be securely located on the wall brackets. Using
a spirit level to adjust the angle of the cabinet by turning the screw A with a cross head screwdriver.When the angle is properly
adjusted, tighten the screw B on both hangers. Then secure the base of the cabinet to the wall with provided screw and
over-cap.
5.Close and secure the internal top electrical cover with the small screws removed earlier. And switch on the electrical supply at
the mains to test the function of the lamp and the shaver socket.
6.Insert the shelf supports in the desired positions starting with the top shelf. On the double door item, one of the doors should
be removed so the glass shelves can be inserted. Please make sure to tighten the plastic screw at the bottom of the shelf
support to prevent the shelves becoming loose. Rubber plugs provided can be used to cover unused shelf holes.
7.If the doors are out of alignment, please first remove the soft-close buffer (from bottom hinges), then adjust the screws A, B
and C on hinges for 3 directional adjustment, see below diagram.
1.
2.
3.
4.
A
B
C
A
Advertisement
