Table Of Contents; Legislation - Baxi 7703233 Installation, Commissioning And User Instructions

Outdoor Sensor Kit (QAC34)
The Outdoor Sensor is suitable for use with the
following boilers:-
BOILER GROUP 'A'
Baxi Duo-tec Combi range
Baxi Platinum Combi range
Main Eco Elite Combi range
Potterton Promax Combi range
Potterton Gold Combi range
Potterton Titanium Combi range
BOILER GROUP 'B'
Baxi 100 Combi range
Potterton Promax Ultra Combi range
BOILER GROUP 'C'
Baxi EcoBlue + Combi & Advance Combi ranges
BOILER GROUP 'D'
Baxi 200 Combi range
Baxi 400 Combi range
BOILER GROUP 'E'
Baxi 600 Combi range
Potterton Assure Combi range
Refer to the Installation & Service Manual supplied with the
appliance if the boiler being installed is not on the above list.
ErP Information
Regulation EU811/2013, supplementing Ecodesign and
Energy Labelling Directives 2010/30EU
Part This Thermostatic
Number Control Device is rated
Class 'II'
7703233
1.0

Legislation

NOTES: This kit is suitable only for installation in GB and IE and should be installed in accordance with the rules in force.
In GB, the installation must be carried out by a Gas Safe Registered Installer. It must be carried out in accordance with
the relevant requirements of the:
• Gas Safety (Installation & Use) Regulations.
• The appropriate Building Regulations either:-
The Building Regulations,The Building Regulations
(Scotland), Building Regulations (Northern Ireland).
• The Water Fittings Regulations or Water Byelaws in Scotland.
• The Current I.E.E.Wiring Regulations.
Where no specific instructions are given, reference should be made to the relevant British Standard Code of Practice.
In IE, the installation must be carried out by a competent Person and installed in accordance with the current edition of
I.S. 813 'Domestic Gas Installations', the current Building Regulations and reference should be made to the current ETCI
rules for electrical installation.
2
Correction Factor
(Contribution to system
energy efficiency)
2 %
Contents
Section
1.0 Legislation
2.0 Introduction
3.0 Contents of pack
4.0 Fitting the outdoor sensor
5.0 Connecting the outdoor sensor
boiler group 'A'
6.0 Setting the outdoor sensor curve
boiler group 'A'
7.0 Connecting the outdoor sensor
& setting the curve boiler group 'B'
8.0 Connecting the outdoor sensor
boiler group 'C'
9.0 Setting the outdoor sensor parameters
boiler group 'C'
10.0 Operating instructions outdoor sensor
boiler group 'C'
11.0 Fault finding boiler group 'C'
12.0 Connecting the outdoor sensor & setting
the slope boiler group 'D'
13.0 Connecting the outdoor sensor & setting
the curve boiler group 'E'
14.0 Notes
15.0 User Information
Page
2
3
3
4
5
6
7
8
8
9
10
11
12
13
15
7703237-01 (3/18)