Download Print this page

Tumbl Trak Jr. Bar Pro Assembly Instructions

Assembly Instructions

Jr. Bar Pro

Parts List:

(1) kip bar subassembly

(2) vertical supports

(1) center-beam

(2) side legs

(2) spring-detent knobs (D-2)

(4) hand-knobs (D-1)

(1) 6mm allen wrench

(4) button-head cap screws

(4) lock washers

(4) flat washers

Thank you for

purchasing the Jr. Bar

Pro. We hope you will

enjoy years of use of

this product.

After opening the

boxes, please check the

parts list to make sure

all pieces have arrived

in good condition. If

you have any questions

during this assembly

process, please call

customer service

at 1-800-331-4362.

Table of Contents

Do you have a question about the Jr. Bar Pro and is the answer not in the manual?

Page 1: Assembly Instructions
Assembly Instructions Assembly Instructions Thank you for purchasing the Jr. Bar Jr. Bar Pro Jr. Bar Pro Pro. We hope you will enjoy years of use of this product. After opening the boxes, please check the parts list to make sure all pieces have arrived in good condition.
Page 2 -release knob, assuring that the pin goes into the appropriate tube hole -tighten knob (turning clockwise) until knob is fully seated against the tube, holding it securely Example – detent-pin is protruding NOTE: Tumbl Trak equipment is not recommended for the use in Parkour/Free Running related activities. General Guidelines Example –...
Page 3  Non-skid material on the bottom prevents sliding  Air Barrel and Cradle This is a great station to use with your Jr. Bar Pro  Put the Air Barrel behind the bar and do drills for Kips  and straight arm bouncy butt drills Let you imagination go and you will discover so much ...