Advertisement
Do not sign for any goods that appear damaged or tampered with.
No assembly is needed on any H-ROOT Electric Tables.
When the table is unpacked from the box both the power cable and foot pedal will need to
be united, and then plugged into the wall.
UNPACKING INSTRUCTIONS:
Do not use sharp objects or a knife when unpacking to avoid damage to the upholstery or paint.
Lift off carton lid carefully and either lift table (4 person job) out of carton. Otherwise,
carefully cut the end of the carton and slide table out. Make sure that the wheels are not
locked when you do this.
Check the voltage rating on the serial plate of the motor. The plug of the motor should only be inserted
into 110V or 220V power outlet as indicated on the serial plate.
OPERATING INSTRUCTIONS
Powerlift Operation:
With single motor tables one foot pedal is supplied. The pedal depresses when pressure
is applied. Use your foot to apply pressure on the end corresponding to the direction in
which you would like the table to go.
Take care not to run over the foot pedal cable when moving the table.
Avoid jerking the foot pedal cable.
WARNING: Do not hold foot pedal down after motor has reached its maximum
or minimum point. This may damage the motor and frame and will not be covered by
warranty.
Manual Head Section Adjustment:
Support the section to be adjusted with one hand and turn the lock
release handle towards the centre of the table to raise a section.
Keep pressure on the lock release handle until you have manually adjusted the section to the desired height or
angle and then release to automatically lock into place.
To lower a manually adjusted section follow the directions above but
turn the lock release handle towards the end of the table.
Prime Alternatives
Free call 1800 333 505
Advertisement
