RINS1778-1
Connection to the Enforcer/HomeControl+ panels:
When connecting the communications module, make sure that
the control panel is fully powered-down (mains and battery).
Enter the Engineers menu on the control panel and then go to
COMMUNICATIONS? -> Data Network Set-up? -> Program
WiFi -> Setup with Wi-Fi Device?
Press to enter the SSID and password of your router
manually (pressing YES after each entry )- or see the other side
of this lea et for setup using a smartphone, tablet or PC.
NOTE: SSID /Passwords should not have a space at the
beginning or end and must not exceed 32 characters in length.
Firewall compatibility:
In cases where there is a strong FIREWALL it will
be neccessary to assign the network details into
the modem manually.
NOTE: It is important in such cases to notice
that if the rewall has all ports closed then the
system administrator must open ports TCP
25010 (Insite UDL) , 25000 (panel) and 443
(App) for OUTGOING TRAFFIC ONLY to allow
UDL and use of the
HomeControl+ APP.
T: +44(0)845 6434 999 (local rate) Or T: +44(0)1709 535225 (For Alarm Engineer only)
Customer Support opening hours: 8:00am – 6.30pm Monday to Friday
DIGI-WiFi
Operation LEDs:
Single pulse:
No Cloud
connection.
Single-Double
alternating
pulse: Cloud
connected
DIGI-WiFi
Modem data and power connection:
MUST USE SUPPLIED CABLE. DO NOT RE-USE
CABLES FROM DIFFERENT COMMs MODULES.
On at startup.
Also pulses
rapidly during
network setup
procedure
(steps 1 - 4)
Double Pulses:
when APP
connected
Not Used
DIGI-WiFi
Network
Communications
Module
(Clips into
Place)
Pulses to
indicate local
network
tra c