Table of Contents
Advertisement
Quick Links
User Manual
S A A W A R D S O F
S A A W A R D S O F
S A A W A R D S O F
E X C E L L E N C E
E X C E L L E N C E
E X C E L L E N C E
2 0 1 7 G O L D
2 0 1 7 G O L D
2 0 1 7 G O L D
AWARDS OF
QLD AWARDS OF
SA AWARDS OF
NSW & ACT AWARDS
EXCELLENCE
EXCELLENCE
EXCELLENCE
OF EXCELLENCE
2017 GOLD
2017 GOLD
2017 GOLD
N A T I O N A L
Heatseeker UniPanel®
Advertisement
Table of Contents
Troubleshooting
Summary of Contents for Supreme Heating Heatseeker UniPanel
- Page 1 2 0 1 7 G O L D AWARDS OF QLD AWARDS OF SA AWARDS OF NSW & ACT AWARDS EXCELLENCE EXCELLENCE EXCELLENCE OF EXCELLENCE 2017 GOLD 2017 GOLD 2017 GOLD N A T I O N A L Heatseeker UniPanel®...
- Page 2 Head Office Bundoora VIC 3083 P: (03) 9460 4200 info@supremeheating.com.au NSW Office Smeaton Grange NSW 2567 P: (02) 4648 4766 solar.nsw@supremeheating.com.au salesnsw@supremeheating.com.au QLD Office Brisbane QLD 4001 M: 0455 064 765 solarqld@supremeheating.com.au SA Office Wingfield SA 5013 M: 0437 947 375 solarsa@supremeheating.com.au WA Office South Fremantle...
-
Page 3: Table Of Contents
User Manual Heatseeker UniPanel® Solar Pool Heating Published September 2017 Controller Troubleshooting General Information No Power To The Display Introduction to Heatseeker UniPanel® Pipe/Roof Sensor Faults Specifications Pump Faults Installation and Connection Installer Setup Safety Additional Information Solar Location Solar Pump Operation... -
Page 4: Heatseeker Unipanel® Solar Pool Heating
This manual provides installation and operating instructions for the Heatseeker UniPanel® solar pool heating system. Read this manual carefully before proceeding with the installation and operation of your solar system. Consult your Heatseeker UniPanel® distributor with any questions regarding the equipment. - Page 5 Specifications 1136 PORT TO PORT WIDTH 1114 PANEL WIDTH ACROSS EDGES 48.3 MANIFOLD PORT DETAIL PORT DETAIL Heatseeker UniPanel® Solar Pool Heating...
-
Page 6: Installation And Connection
Will the solar system fit on the roof? This has to be established from the ground or a ladder with OH & S Regulations preventing access to the roof without a harness or rail system. A quick measurement in most cases can be taken at ground level. Heatseeker UniPanel® Solar Pool Heating... -
Page 7: Typical Arrangement
Typical Arrangement Heatseeker UniPanel® Solar Pool Heating... -
Page 8: System Assembly
System Assembly Panel/PVC Coupling Cover Rail End Cap Adaptor Manifold Rail Channel Port Insert Fixing Clip Slider Manifold Lock Nut Rail Joining Strip Coupling Aluminium Rail Heatseeker UniPanel® Solar Pool Heating... -
Page 9: Accessories
Accessories Rail Mounting System Rail End Cap Rail Channel Slider Lock Nut Aluminium Rail Rail Joining Strip Accessories List Manifold Coupling Coupling Cover Manifold Port Insert Panel/PVC Adaptor Manifold Fixing Clip Heatseeker UniPanel® Solar Pool Heating... -
Page 10: Controller Operation
Controller Operation Controlling your solar system may no longer be a daily chore. Supreme Heating has combined the latest technology, together with user friendly concepts in the development of our extensive range of automatic controllers. AquaGen 5 Operating Instructions The AquaGen 5 is a premium range of automatic solar controllers with temperature adjustment, heating, manual and standby mode features. -
Page 11: Mode Button
Due to rounding the actual heat may vary by up to ±½°C. The ability to solar heat the pool will depend on weather conditions. The factory default for SOL. LIMIT is 30°C Heatseeker UniPanel® Solar Pool Heating... -
Page 12: Enter Button
For hours of solar operation (24hr Clock) First selecting the start time in hour intervals (6:00 – 12:00) Then the end time (12:00 – 21:00) HOURS Factory default for installer setup is run from 12:00-12:00 (24hrs). Heatseeker UniPanel® Solar Pool Heating... -
Page 13: Controller Troubleshooting
If the controller reports a short circuit, then the cable is fine and you may replace the sensor end if re-routing a new cable is not possible. If the controller reports a short circuit while the cable is unplugged, then the controller requires repair. Heatseeker UniPanel® Solar Pool Heating... -
Page 14: Pump Faults
This can occur if the unit has been turned off for a prolonged period of time. Leave the unit on RTC-FAIL for 30 seconds and this will allow charging of the supercapacitor. Next, turn it off for 30 seconds before turning it back on. Heatseeker UniPanel® Solar Pool Heating... -
Page 15: Installer Setup
6. Degree of protection against moisture: IP33. 7. Store pool chemicals at least 3 metres safely away from all pool equipment. 8. If the power cord is damaged, do not use the controller; return the unit to the supplier for repair. Heatseeker UniPanel® Solar Pool Heating... -
Page 16: Solar Pump Operation
Solar Pump Operation At Supreme Heating we only use quality pumps for our solar installations. The pool plumbing configuration will determine what type of pump is used. Warning! Hazardous Suction Do not block water entry into filtration system with any part of your body as the pressure can trap hair or body parts, causing severe injury or death. -
Page 17: Starting The Pump
This should be carried out as described above. Water Quality Maintaining balanced water chemistry is important to the life of your pump. Please consult your local pool shop regularly to have your water tested. Heatseeker UniPanel® Solar Pool Heating... -
Page 18: Emptying The Hair And Lint Pot
• Water leaking from seals – Check that O-rings on both union connections and pump lid are greased and are not pinched or damaged. PUMP LEAKING • Water leaking from pump body – Contact manufacturer for repair options. Heatseeker UniPanel® Solar Pool Heating... -
Page 19: Maintenance
Debris should be removed from the surface of the panels and around the rail track mounting system twice yearly. A build of debris will affect thermal performance if left on the surface of the panels and can prevent the rail fixing mechanisms to function correctly. Heatseeker UniPanel® Solar Pool Heating... -
Page 20: Vacuum Relief Valve
The solar pump must be turned off before cleaning commences. Vacuum relief valve maintenance Failure to correctly install a vacuum relief valve in your system or inspect and maintain its operation will void all warranties related to panels, pipe work and fittings. Heatseeker UniPanel® Solar Pool Heating... -
Page 21: Solar Pump
8. Do not add pool salt, chlorine, acid or other chemicals directly to your skimmer. Do not add chemicals directly to skimmer This may result in damage to your pump and may void your warranty. Heatseeker UniPanel® Solar Pool Heating... -
Page 22: Warranty Agreement
(g) by other abuse or misuse caused by the Purchaser a three (3) year limited warranty from Dontek or a third party. Electronics Pty Ltd, 19 Melrich Road, Bayswater, Victoria, 3153 (Phone: (03) 9762 8800, Email: service@dontekelectronics.com.au); or Heatseeker UniPanel® Solar Pool Heating... - Page 23 Product if such examination by Supreme Solar Pty Ltd reveals that the Product: (a) is not defective; or (b) is defective as a result of any of the events specified in paragraph 7. Heatseeker UniPanel® Solar Pool Heating...
- Page 24 1300 787 978 supremeheating.com.au...
Need help?
Do you have a question about the Heatseeker UniPanel and is the answer not in the manual?
Questions and answers