Salus MD22A Operation Manuals page 4

In determining a suitable location for installation, it is important to ensure
you allow adequate access for servicing.
The following instructions are designed to assist engineers in the safe
and effective installation and servicing of the SALUS Mag Defender and
should be followed at all times. Any queries arising from either installation
or servicing, contact SALUS Controls direct on 01226 323961.
Dos:
• Install the filler upright to enable the device to be fully evacuated of
air during commissioning. Pipe runs are vertical, horizontal or any
angle in between. The inlet and outlet can also be swapped to suit.
• Where the device is fitted to the metallic building structure earth-
bonding continuity is required around the device. All bonding
connections must be accessible and labelled "Safety Electrical
Connection - Do Not Remove"
Don'ts:
• Magnets may affect or interfere with sensitive mechanical and
electronic instruments such as heart pacemakers, computers/magnetic
media and watches. Always keep magnets at least 300mm (1ft) away
from such equipment.
• NEVER close the INLET or OUTLET isolation valves, or UNDO the lid when
the pump is running!
4
MD22A INSTRUCTION MANUAL