INTRODUCTION The Pro-User SC1600A is a member of the family of advanced mobile Jump Starters manufactured by Pro-User Europe GmbH. The Pro-User Jump Starter enables you to securely start your 12V vehicle in case your battery is weak. The Supercapacitor Jump Starter SC1600A with up to 1600A peak power is designed to jump start 12V vehicles with gasoline or diesel engines.
Page 4
General: • Electrical devices are not toys. Keep the product away from children. There can be dangers that can´t be recognised by children • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they are supervised or have been instructed on how to use the appliance by a person responsible for their safety.
Page 5
Working with Batteries • Batteries can store large amounts of energy and improper handling can be dangerous. Never connect to a battery with an unsuited voltage or other unsuitable or damaged batteries • Keep children away from batteries and acid. •...
Intended use The PRO-USER SC1600A Jump Starter is intended to jump start any 12V car or truck. After each failed attempt to jumpstart your car, take a break for at least 3 minutes to avoid overheating. With the unit on board the vehicle, you may start your vehicle´s motor even with a weak or dead battery in case of need.
TECHNICAL DESCRIPTION Item Description Battery clamps LCD Display Power-button LED-button Backup-battery-button (Boost-button) LED-light 12V 10A input 5V 2A USB input Carrying handle Car battery voltage Supercapacitor voltage Inner resistance of the car battery State of charge of the internal backup battery (in %)
3 months to keep the battery in good condition and being able to jump start at any time. Not charging the SC1600A every 3 months can cause a permanent damage to the internal battery and can result in a broken unit.
Page 9
Alternatively you may use the cigarette-lighter-charging cable: Use the including 12V charging adapter to connect to the 12V charging input (7) of the SC1600A and the vehicles 12V output. Some vehicles may require to turn the ignition on to apply voltage to the 12V output. Pre- charging the supercapacitor with this method can take up to 5 minutes.
Page 10
USB output of a computer or an USB power-bank. Connect the USB power source to the micro-USB-charging input (8) of the SC1600A The supercapacitor voltage has to be 15 Volts to be able to jump start a vehicle. This charging method will take up to 40 minutes.
Attention: Always follow the specific order to reduce of the risk fire and explosion. Connect the SC1600A to the vehicle´s battery and prepare the device as described. Make sure the supercapacitor is charged and the LCD display shows “JUMP START READY” (wait 10 seconds before operation).
TECHNICAL SPECIFICATIONS Model Jump Starter SC1600A Applicable scope: Note: This information is just as a reference and can vary upon the brand and type of car, the age Jump start 12V Gasoline and Diesel vehicles and condition of the battery and the outer temperature.
Need help?
Do you have a question about the SC1600A and is the answer not in the manual?
Questions and answers