Advertisement
KTA Instructions
Thread the cable through the strain relief. Insert the bared ends of the two wires of the cable into either one of the
slots on the terminal block and secure by tightening the screws in each slot. Slide the terminal block cover into
place and secure with four sheet metal screws. Tighten nut on strain relief securely to jacket of cable.
5. F
W
AN
IRING
Push cable connector end over pins of socket on side of fan. There is an alignment guide within the two connectors.
Slide the locking ring on the cable side of the connector over the fan socket and rotate to the right until it snaps
into place.
6. I
A
NDICATOR
After final installation of system ductwork, fan, power supply, and wiring, the system should be ready to turn on.
Plug in the 6 foot electrical cord directly into a 120 volt AC wall socket, and turn on the switch on the right side of
the KTA box.
http://radonpds.com/Instructions_KTA/Instructions_KTA.htm[8/16/2010 11:14:41 AM]
:
DJUSTMENT
Advertisement
