PNI SM400 User Manual

MANUAL DE UTLIZARE
Telecomanda pentru kit casa
inteligenta PNI SmartHome SM400
Section 1 -
Programming the Remote with M-Series Main Console
NOTE: You can program in total up to 4 security keychain remotes or keypads
to your M-Series Alarm System.
NOTE: The security keychain remote must be programmed in Zone 1.
1. Press the learn button on the back
of the M-Series Main Console for
3 seconds until the Zone 1 light
is ashing.
2. Press any buttons on the
keychain remote.
3. Once the keychain is programed to
the M-Series Main Console, the zone 1
LED light will be off.
Section 2 -
NOTE: Programming the keychain remote with the SkylinkNet Internet Hub
must be done from the SkylinkNet App.
LED
Learn Button
1. Go to "More" and tap
on "System Settings".
4. Tap on "Security
Remote/Keypad".
Programming the Remote with SkylinkNet Internet Hub
2. Tap on "Setup 3. Tap on "Add Device".
Wizard".
5. Name your Security 6. Tap on the "Learn Now"
Keychain Remote and button and press any button
tap "Continue". on the keychain remote.

Section 3 - Operation of the Security Keychain Remote

NOTE: A red led will ash when pressing any buttons on the remote.
Arm Away
Select "Arm Away" to protect your
home when you're away. This mode
activates or triggers the alarm
after a default set of time, giving you
enough time to get in and out of
your house to arm/disarm the
alarm system.
Arm Home
Select "Arm Home" to protect while
you're at home. This mode deactivates
motion sensors but leaves other
sensors activated.
Disarm
Select "Disarm" to
deactivate the alarm system.
Panic Button
Press and hold the Panic
Button for 3 sec. to
activate the alarm.