KENT Fairlight Owner's Manual page 6

INSTALLATION
CLADDING INSTALLATION
Please note that the heater fascia is smaller than
the front of the zero clearance outer casing. So,
when you are fitting the cladding to your
enclosure, you will need to 'sandwich' the
cladding in between the heater fascia and the zero
clearance casing.
Please refer to the following steps to assist you in
fitting the cladding to the front of your enclosure.
Before you proceed, we recommend you remove
the door by lifting it up and off the hinge bracket.
1
Remove the Fascia
a. Firstly, remove the bottom bar from the fascia
assembly. Lift the bottom bar up and away
from the fascia assembly.
a
b. The fascia body is attached by 4 screws.
Remove these screws and set them aside.
Carefully slide the fascia forward to remove.
Please be aware that the fan wiring is
connected to the rear of the fascia. This wiring
will need to disconnected prior to installing the
cladding. You will need to reconnect the
wiring, so please take note of the connections.
If unsure of any electrical connections or any
problems arise, please contact an electrical
contractor.
6
- INSERT MODEL ONLY
b
2
Reposition Heater Body
There are 2 screws
holding the heater
body to the zero
clearance casing.
These are located
at the bottom, in
front of the fans.
U n d o t h e s e 2
s c r e w s a n d s e t
aside.
Slide the heater body forward to allow for the
cladding to fit in between the zero clearance
casing and the heater body.
T h e g a p s h o w n b e l o w o n l y n e e d s t o
accommodate the thickness of the cladding.
allow for
cladding
thickness
3
Cladding Cutout Dimensions
The cutout for the cladding should be 585 mm
high by 980 mm wide.
The bottom of the cutout should sit up against the
base of the heater body casing.
Follow step 1 in reverse to reattach the fascia.
screws located here