Advertisement
Wireless Remote
Position the remote and charging base in a
location away from prolonged direct sunlight.
ENTER
E
Wireless Remote
The wireless remote uses the Polaris
able Lithium ion battery (part #E33). The battery
must be charged for at least five (5) hours before
use. Charging is indicated by an animated scroll-
ing of the battery symbol on the display.
With a full charge, the remote can operate for up
to two days, depending on usage. It is normal
for the battery to discharge when not in use. To
ensure a full charge, always store remote on the
charging base when not in use. To replace the
battery contact a Polaris service professional.
Wireless Remote Setup
System measurements and settings are displayed
on the remote display screens. Adjustments are
made with the keypad. Use the cursor control
(arrow) keys to move through the screens and
menu options. Use the enter key to select an item.
Display settings such as brightness, contrast,
etc. as well as certain device-specific settings are
adjusted separately for each display device using
the display setup screens.
For a complete description of using the
wireless remote, refer to the EOS
Maintenance Guide or EOS Owner's Manual.
If the remote is purchased with the Eos Command
Center, it is factory set for communication. If the
remote is purchased separately or is a second
remote on the system, it must be configured for
communication via the setup screen.
To access the Wireless Remote Setup screen:
1. Press the left and right arrow keys on the
remote simultaneously to open the Wireless
Remote Setup screen.
E
Wireless
Antenna
When activated, the Audible Alarm in this
recharge-
®
device signals when an alert condition exists.
Alert messages are displayed on the Main screen.
Select Contrast and Backlight to adjust the
display features to user preferences.
To configure remote for communications:
1. Select Network Settings and press <Enter>
3. If two remotes are used with the antenna,
2. Enter the system SSID and Key number. The
Installation and
®
Wireless Remote Setup
Software Versions
Network Settings
Shutdown
Audible Alarm
Spa Temp Notify
Access Code
Contrast
Adjust
Backlight
Adjust
Sleep Timeout
3 min
to open the Network Settings screen.
assign each remote its own unique Remote
Address. (Ex: first remote is set to 101 and
second is set to 102)
SSID is the antenna serial number (located
on left side of the antenna) with three leading
zeros. The Key consists of two rows of
numbers, the second row is the serial
number with four leading zeros.
Network Settings
Remote Address
Network Settings
Channel
Encryption
SSID
000042105083
Key
0000000000000
0000042105083
RSSI
No Signal
® 2005 Polaris Pool Systems. All rights reserved. TL-553 11/05
Battery
Charge
Signal
Strength
Move cursor over
folder icon. Press
<Enter> to select
and open new screen.
Press <Enter> to
select and activate.
Up/down keys
adjust setting.
101
802.11a
Auto
Advertisement
