OverskyRC Warlark-80 Manual

The flight control board of Warlark-80 is based on F3 EVO hardware, supports both CleanFlight and

BetaFlight firmware. There are 3 kinds of hardware for its built-in compatible receiver: A---CYRF6936,

B---CC2500，C---A7105. There are 6 optional protocols for the built-in compatible receiver: 1=>DSMX/2; 2

=>DEVO (on testing); 3 =>Futaba SFHSS; 4=> FrSky (on testing); 5=> FlySky AFHDS; 6=>Hubsan(on

testing);

Warlark supports plug and play VTX-25MW analog video transmitter module or VTX-25MW &

OSD(WM OSD) module and analog camera.

Fetures:

1） F3 EVO flight control board

2) Optional built-in receiver

3) Diagonal motor to motor distance: 80mm

4) 7*16mm high KV brushed motors

5) 35mm ducted fan props

6) Working voltage: 3.7V(1S lipoly battery)

7) Flight weight: 39.4g (FPV with OSD version), 35.0g(No FPV version)

8) Flight time: 4 minutes (FPV with OSD version, 5 minutes (No FPV version)

9) No soldering for mounting VTX-25MW analog video transmitter module or VTX-25MW&OSD module

(note: the analog VTX is 40CH)

10) The working frequency of the VTX is controlled by transmitter

11) Supports parameter setting up through transmitter (only FPV with OSD version gets the function)

Warlark-80 Manual

Table of Contents

Need help?

Do you have a question about the Warlark-80 and is the answer not in the manual?

Page 1 Warlark-80 Manual The flight control board of Warlark-80 is based on F3 EVO hardware, supports both CleanFlight and BetaFlight firmware. There are 3 kinds of hardware for its built-in compatible receiver: A---CYRF6936, B---CC2500，C---A7105. There are 6 optional protocols for the built-in compatible receiver: 1=>DSMX/2; 2 =>DEVO (on testing);...
Page 2 According to the above picture: put THR stick to middle position, YAW to rightest, PIT to topmost, and then enters FC parameter setting up mode. The following pictures are the setting up options: Note: 1) For the explanation of each setting option, please check Cleanflight and BetaFlight manual...
Page 3 2) Please check MW OSD manual for OSD setting up 3) The background of the above picture is purpose-made Binding operation: There are two ways for binding operation: one is long press(2 seconds) the button and enters binding mode; the other is time out binding. The Flight control board with Futaba SFHSS compatible receiver and FrSky receiver belongs long press binding mode.