GentleTent GT HOME 410 Disassembly Manual

Disassembly manual for GT Home awnings
GT HOME VAN | GT HOME 310 | GT HOME 410
Thank you for choosing one of our GentleTent awnings! It takes a bit of practice and a
suitable guide to fold it up to its initial packing size. Follow the following guide step by step!
We hope you have a good "Coming Home" with your GentleTent awning.
1 Release the guy lines you used to fix
the tent to the ground and, depending
on wind conditions, pull out the ground
pegs.
TIP: During stronger winds leave the
4-6 ground pegs that hold down the
tent for the time being.
4 Close all zippers at the front of the
tent except for the ones on the left and
right side.
6 Finally, open both valves of the awning's
main tubes (at one broadside on the in- &
outside) and let the tent collapse.
TIP: If you have the time, leave the awning
for 15 minutes, so some air is squeezed out
by the tent's own weight.

Preparation

1
2 Open the zipper of the car-con-
nection that attach the awning to the
vehicle.
4
5 Release the cross strut on the interior. Open the valves and squeeze air out of the
tubes, starting at the top and working towards the valves, 1-2x until all air has escaped.
When the tubes are empty, close the valves again.
NOTE: The same applies for the additional air tube in the front of the GT Home 410.
2
3 Close rolled up curtains at the win-
dows and ventilation openings on the
in- and outside.
5
6
3
5
6
Page 1 of 3