Moxa Technologies MD-219 Series Quick Installation Manual

MD-219 Series

Quick Installation Guide

First Edition, September 2014
Overview
The MD-219 is the 19-inch version of our marine display series.
Designed for durably reliable service as an ECDIS display
component, the MD-219 has a 5:4 aspect ratio, alongside full
range dimming and optional optical bonding, making it well-suited
not only for ECDIS applications, but for a variety of other bridge
applications as well.
The MD-219 features both AC and DC power inputs, and may be
conveniently installed on any bridge, without the need for extra
hardware.
Moxa's marine displays are compliant with the most important
industrial marine standards, including IEC 60945, DNV, and
IACS-E10, giving strong assurance of their suitability for marine
applications.

Package Checklist

Before installing the MD-219 Series, verify that the package
contains the following items:
• MD-219 display
• VGA cable
• DVI-D cable
• 2-pin terminal block x 1
• 5-pin terminal block x 2
• Documentation and software CD
• Quick installation guide (printed)
• Warranty card
NOTE: Please notify your sales representative if any of the above
items are missing or damaged.
P/N: 1802002190010
– 1 –

Hardware Installation

Appearance
SavvyTouch Display Control Buttons
The following table describes the SavvyTouch display controls on
the front surface of the MD-219. These intelligent controls light up
in response to a simple wave of the hand over the area of the
screen where they are located.
Name Display Control Function / Color Legend
Color
Display is powered on and
functioning normally. Touch the
Green
button to show the OSD settings
Menu/
menu
Power
No input signal detected. Display
Red
standby
Off Power is down and the display is off
+: To increase brightness of panel
Brightness White
-: To decrease brightness of panel
Off AC/DC power functioning normally
Info
Red AC/DC power error
Switch between DAY/DUSK/NIGHT
Display White
brightness modes
mode
Off Panel brightness out of default range
– 2 –
Installing the MD-219
Desktop
The MD-219 comes with optional brackets that allow you to install
the display on a horizontal surface, such as a desktop. Three round
screws are required for each bracket. See the figure at the top of
the next page for detailed screw specifications, including the
required torque values.
Place your MD-219 display on a clean, flat, well-ventilated desktop.
To protect the display from overheating, leave some ventilation
space between the MD-219 and other equipment. Do not place
equipment or objects on the panel, as this might damage internal
components.
– 3 –