SAFEQUIP ResQcraf 380 Operation & Maintenance Manual

Resqcraf series

Advertisement

Quick Links

ResQcraft Operation & Maintenance Manual
© Safequip 2015

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ResQcraf 380 and is the answer not in the manual?

Questions and answers

Summary of Contents for SAFEQUIP ResQcraf 380

  • Page 1 ResQcraft Operation & Maintenance Manual © Safequip 2015...
  • Page 2: Table Of Contents

    Wear Patches & Fendering ..................8 Transportation Stowage Valise ................. 8 Fittings ......................... 16 Fittings Illustrated View ..................16 Loose Accessories ......................9 Fittings Parts List ....................16 Optional Extras ......................9 Safety .......................... 17 Warranty ........................17 Notes ........................... 18 www.safequip.co.uk...
  • Page 3: Operation

    Operation & Maintenance Manual Operation ResQcraft Arrangement www.safequip.co.uk...
  • Page 4: Introduction

    Craft from the SIT 380 to 530 range are in service throughout the United Kingdom The SIT range of craft can be equipped for air drop/helicopter deployment, 4 and several European countries. Their performance and handling are proven to point lift, towing, and self-recovery. compete with any other craft in its class. www.safequip.co.uk...
  • Page 5: Features & Accessories

    Deck + Keel Volume (Litres) Cylinder Sleeve Optional extra Stowed Weight (kg) Pump and Repair Kit Stowed Dimensions (m) Stowage Valise Length Tow Points Rear Width Tow Points Forward Height * All table data is an approximation, every craft will vary slightly. www.safequip.co.uk...
  • Page 6: Buoyancy Tubes

    These allow individual chambers to be inflated and topped up during pressure, its ICV opens and allows the next chamber to fill. The third chamber to service and for all chambers to be deflated quickly. fill will be the “V” shaped bow chamber. www.safequip.co.uk...
  • Page 7: Deck & Keel

    150DTTM deck and its superior rigidity rubber wear protection strip, bonded to the underside of the hull skin. negate the need for a cumbersome rigid deck plate or extra tubes under the deck, as used on other crafts. Keel Strake www.safequip.co.uk...
  • Page 8: Fit-Out

    Transportation Stowage Valise For transportation of the craft, it is stowed in a heavy duty fabric valise secured with 4 large plastic buckles. The bag includes 6 moulded handles for easy carrying. www.safequip.co.uk...
  • Page 9: Assembly & Inflation

    (ICV) to the next chamber releases to allow air into that chamber. The push fitting within the valve can be opened to release air by turning anti-clockwise, however ensure the valve is turned fully clockwise in order to inflate. www.safequip.co.uk...
  • Page 10: Manual Inflation (Procedure)

    Ensure the valves are not blocked or covered. Manual Inflation (Top Up) If there is a loss of pressure in any of the chambers, the corresponding inflation valve can be used to top up to factory pressure. www.safequip.co.uk...
  • Page 11: Drainage Trunks

    (Fig.7) closed position unless drainage is coming out of the clam cleat and required. To close pull the line down allow line to pass back through the through the cleat until the trunk is cleat, (Fig.6) fully raised. (Fig.5) www.safequip.co.uk...
  • Page 12: Deflate & Re-Packing Procedure

    Turn centre spigot of Fasten and tighten clips. inflation valve anti-clockwise. Allow air to escape. (Fig.8) If available, use extraction pump to remove the air within the craft. Leave deflate valves open throughout packing procedure and when in the stowage valise. www.safequip.co.uk...
  • Page 13: General

    Do not attempt to use harsh solvents without expert advice. Re-effect any emergency repairs – Get professional help for major repairs. Clean product by washing with water and a mild detergent. Storing the product wet and dirty will not immediately damage the product but may shorten its life. www.safequip.co.uk...
  • Page 14: Repair Of Inflatables

    If puncture/tear is within 1” of a seam, contact Safequip or SIT for technical back of a spoon or a narrow roller. Rub from the centre, outwards, making sure advice.
  • Page 15: Transom

    Operation & Maintenance Manual Transom Illustrated View Transom Parts TRANSOM Transom Engine Mounting Plate Engine transom Pad Large Flow Scuppers Self Bailer Rope Cleat Lift Point Keel Drain Bung and Socket www.safequip.co.uk...
  • Page 16: Fittings

    Fittings Illustrated View Carry Handle Re-Right Lines External Lifeline Internal Lifeline 2” D ring on 5” Patch Life line Tunnel on 5” Patch Combined D ring and Lifeline Tunnel Combined D ring and Lifeline D ring Reinforced D-Ring Patch www.safequip.co.uk...
  • Page 17: Safety

    Warning Low Pressure Inflatable Warranty Inflatable Hypalon® products supplied by Safequip Ltd are manufactured under The use of solvents can be highly flammable, Irritating to skin and prolonged BS EN ISO 9001: 2008 quality standards and come with a 2 year manufacturer’s exposure or inhalation may cause serious harm.
  • Page 18: Notes

    Operation & Maintenance Manual Notes SERIAL NUMBER ......................DATE OF PURCHASE ....................SERVICE RECORD DATE OF SERVICE COMMENTS / DEFECTS PERSON CARRYING OUT SERVICE SIGNATURE NEXT SERVICE DUE Address Details ..........................................................................................................www.safequip.co.uk...
  • Page 19 Operation & Maintenance Manual Notes www.safequip.co.uk...
  • Page 20 FK10 2PB Tel: +44 (0) 1259 727835 Fax: +44 (0) 1259 727825 Email: sales@safequip.co.uk Website: www.safequip.co.uk REPAIRS & SERVICING Safequip Ltd (Service Center) Unit 1 Dukes Court Industrial Estate Prudhoe Northumberland NE42 6DA Tel: +44 (0) 1661 830232 Email: repairs@safequip.co.uk ©Safequip 2015...

This manual is also suitable for:

Resqcraf 400Resqcraf 470Resqcraf 500Resqcraf 530

Table of Contents