Advertisement
3. Align the two snaps underneath the Mini Monitor
to the two snaps on the worksurface mat. Apply
downward force on the monitor once aligned to
snap the Mini Monitor into place.
Worksurface Mat
Figure 4. Connecting the Mini Monitor to the push and
clinch snaps on a worksurface mat
4. Locate an appropriate AC outlet nearby the Mini
Monitor, and test it for proper wiring and grounding
prior to use. The Desco AC Outlet Analyzer or
similar test equipment may be used to verify the
outlet's functionality. Use item number
120VAC North American outlets and item number
98131
for 220VAC UK outlets.
5. Connect the power adapter to the power jack
located on the top-side of the Mini Monitor. Route
the wire from the supply to the tested AC outlet, and
plug it into the outlet.
Installation onto Micastat® Laminate
Materials Needed:
2
14244
Micastat® Flush Mount Ground Inserts
1
14242
Micastat® Flush Mount Insert Tool
1
09857
10mm Socket and Rivet (100 per pack)
2 8-32 Button Cap Screws
1. Install the two flush mount ground inserts into the
Micastat® laminate. Space the inserts as shown in
Figure 3.
2. Once the ground inserts are installed, remove the
8-32 screws that were supplied with the kits.
3. Place 10mm snap sockets on top of the installed
brass ground inserts.
4. Screw the 10mm snap sockets into place on the
ground inserts using the 8-32 button cap screws.
5. Align the two snaps underneath the Mini Monitor
to the two snaps on the Micastat® laminate. Apply
downward force on the monitor once aligned to
snap the Mini Monitor into place.
TB-3072 Page 3 of 4
Push and
Clinch Snaps
98132
DESCO WEST - 3651 Walnut Avenue, Chino, CA 91710 • (909) 627-8178
DESCO EAST - One Colgate Way, Canton, MA 02021-1407 • (781) 821-8370 • Website:
6. Connect the power adapter to the power jack
located on the top-side of the Mini Monitor. Route
the wire from the supply to a nearby AC outlet
and plug it into the outlet. Make sure the voltage
and frequency match those listed on the power
supply. The Mini Monitor is now powered, and the
Micastat® laminate is now grounded.
Operation
1. Fit the wristband snugly onto the wrist.
2. Snap the wrist cord to the wristband.
3. Plug the wrist cord into the operator jack. The
green operator LED will illuminate. This indicates
that the operator is properly grounded.
4. If this does not happen, examine the wrist cord for
continuity or damage and the wristband to ensure
that it fits securely. If you have dry skin, apply an
approved dissipative hand lotion such as
Reztore™ ESD Hand
5. When leaving the workstation, first touch the
monitor's park snap. The monitor's audible
alarm will disable for 6 seconds. Use this time to
disconnect the wrist cord from the wristband and
attach it to the park snap without sounding a false
alarm.
for
6. Upon returning to the workstation and disconnecting
the wrist cord from the park snap, the monitor will
provide 6 seconds for the operator to reconnect the
wrist cord to a worn wristband before sounding the
monitor's alarm.
Figure 5. Using the Mini Monitor
Menda
Lotion.
Desco.com
© 2017 DESCO INDUSTRIES, INC.
Employee Owned
Advertisement
