Summary of Contents for DUJARDIN EM1620
- Page 1 OPERATING MANUAL V02 English ELECTRONIC LOCK M-LOCKS BASIC LINE EM1620 / EM2020 / EM2520 / EM3020 / EM3520...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Notes regarding the operating manual ........... 2 Product description ................. 4 Opening of the lock ................. 5 Open with time delay ..............5 Changing code (with the door open!) ..........6 Adding a new code / user ............... 7 Delete second code / user .............. -
Page 3: Notes Regarding The Operating Manual
10 of this operating manual. Dujardin is niet aansprakelijk voor storingen en/of schade welke ontstaat door ondeskundig gebruik, dan wel het met opzet verkeerd gebruiken van de geleverde producten. - Page 4 Important instructions: Your code is personal. Don’t give out your code. Please keep the code always carefully and protect it against improper use by unauthorized persons. When typing in your code cover the keypad so no one near you can see your code.
-
Page 5: Product Description
PRODUCT DESCRIPTION The lock works with a six digit code. At the time of delivery, the lock is set to the standard Manager Code of 123456. Change this code immediately to your own choice of Manager Code. If needed, the owner of the Manager Code can add one user. Symbols and signals: Beep signal Omschrijving... -
Page 6: Opening Of The Lock
OPENING OF THE LOCK Enter the code (Manager Code set at the factory = 1-2-3-4-5- 6). If the code is correct, a double signal sounds. Unlatch the door and open it. If the door is not opened within 3 seconds, the lock will automatically engage again. For model EM3020: to close the lock, press any key. -
Page 7: Changing Code (With The Door Open!)
CHANGING CODE (WITH THE DOOR OPEN!) 1. Press and hold “0” until a double signal sounds. The LED will illuminate when performing the following actions. 2. Enter the old code. A double signal sounds. 3. Enter the new code. A double signal sounds. 4. -
Page 8: Adding A New Code / User
6. ADDING A NEW CODE / USER 1. Press and hold “1” until a double signal sounds. The LED will illuminate when performing the following actions. 2. Enter your personal Manager code. A double signal sounds. 3. Enter the new User code. A double signal sounds. 4. -
Page 9: Setting The Time Delay And Opening Window Time
SETTING THE TIME DELAY AND OPENING WINDOW TIME Time delay : time between first and second code entry in minutes. Opening window time : Time period of time in minutes during which the code can be entered a second time and the lock can be opened (after the time delay has expired) Changing or deleting the time delay values can only be done... -
Page 10: Replacing The Battery
REPLACING THE BATTERY It the lock emits a series of audible tones when opened, the battery is almost exhausted and must be replaced immediately. You may only use 9V ALKALINE Duracell, Duracell Industrial or Energizer alkaline batteries. A. Battery compartment in entry unit: Open the battery compartment and replace the battery by a new one. -
Page 11: Questions Or Problems
10. QUESTIONS OR PROBLEMS? Problems, questions or malfunctions can be reported 24 hours a day / 7 days a week by our general telephone number: +31 345 - 616110 Or during opening hours by e-mail: service@dujardin.nl...
Need help?
Do you have a question about the EM1620 and is the answer not in the manual?
Questions and answers