Appendix; Programming The Remote; Programming Code - LG 26LC2R-TJ Owner's Manual

0323G_2-en_rev04 6/5/06 3:36 PM

APPENDIX

PROGRAMMING THE REMOTE

The remote is a multi-brand or a universal remote. It can be programmed to operate most remote-control-
lable devices of other manufacturers.
Note that the remote may not control all models of other brands.
Programming a code into a remote mode
1
Test your remote control.
To find out whether your remote control can operate the component without pro-gramming, turn on the
component such as a VCR and press the corresponding mode button (such as a D D V V D D or V V C C R R ) on the
remote control, while pointing at the component. Test the P P O O W W E E R R and P P R R + + / / - - buttons to see if the
component responds properly. If not, the remote requires programming to operate the device.
2 Turn on the component to be programmed, then press the corresponding mode button (such as a D D V V D D or
V V C C R R ) on the remote control. The remote control button of desired device is lighted.
3 Press the M M E E N N U U and M M U U T T E E buttons simultaneously, the remote control is ready to be programmed for the
code.
Enter a code number using the number buttons on the remote control. Programming code numbers for the
4
corresponding component can be found on the following pages. Again, if the code is correct, the device will
turn off.
Press the M M E E N N U U button to store the code.
5
6
Test the remote control functions to see if the component responds properly. If not, repeat from step 2.

PROGRAMMING CODE

DVD
Brand
APEX DIGITAL
DENON
GE
HARMAN KARDON
JVC
LG
MAGNAVOX
MARANTZ
70
Page 70
Codes Brand
022 MITSUBISHI
020 014 NAD
005 006 ONKYO
027 PANASONIC
012 PHILIPS
001 010 016 025 PIONEER
013 PROCEED
024 PROSCAN
Codes Brand
002 RCA
023 SAMSUNG
008 017 SONY
003 009 THOMPSON
013 TOSHIBA
004 026 YAMAHA
021 ZENITH
005 006
Codes
005 006
01 1 015
007
005 006
019 008
009 018
010 016 025