Advertisement
Please read this User Manual before using your NightSearcher product, as it
contains important safety information and operating instructions. Following
this advice will help ensure that your product operates to its maximum
potential.
TECHNICAL SPECIFICATION
Light modes
High
Light output
85
(lumens)
Light source
Run time (hours)
1
Battery
Product size (mm)
Product weight
(kg)
Boxed size (mm)
Boxed weight (kg)
Product Code
*flashing mode specifications cannot be measured by ANSI FL1 standard.
Flashing mode runtime is based on measurement of battery capacity
change only.
Supplied with : headlight bracket, headstrap and battery.
LED ASSEMBLY REPLACEMENT
Light Emitting Diodes (LED) can last over 50,000hrs and seldom need to be
replaced.
BATTERY REPLACEMENT
1. Unscrew the end cap and remove it from the unit
2. Remove the old battery and replace with one new 1.5V AA size alkaline
battery, inserting positive end of battery first
3. Replace the end cap
Low
Flashing *
SOS-Flashing *
10
Cree White LED
20
4
23
1x 1.5V AA Alkaline
Ø22 x 95
0.062
W135 x H180
0.072
NS2IN1LED
Attach Angle Light To Headlight Holder
1. Hold the angle light with clip facing the headlight holder.
2. Align the angle light tracks to the fingers of the holder
3. Glide the angle light into the headlight holder.
ON / OFF & MODE OPERATION
The multimode switch is located on one end of the torch and offers rapid
one-handed mode change, even wearing gloves.
After 3 seconds in any mode, pressing switch again turns torch off.
FEATURES
CREE LED – Up to 85 lumens
4 Lighting modes – High, Low & SOS-Flashing & Flashing.
Special designed reflector for projecting search light up to 70m.
Multimode switch for easy selection of modes
Dual purpose : headtorch and flashlight
90° angled light
Integrated clip on housing
Robust aluminium body
MAINTENANCE
Wipe the lens clean with a soft cloth and a non-corrosive detergent.
If putting lamp into storage for a long period, remove the battery.
SAFETY PRECAUTIONS
Do NOT look directly into the LED light for more than a few seconds
Do NOT allow children to use the LED light unless under the supervision of
an adult
Remove the battery if not using the LED light for over 30 days or before
storage
Do not try to repair the unit yourself. Please contact NightSearcher or an
authorised distributor
Do not expose the light to fire/high temperatures or extreme wet/cold
conditions
Advertisement
