Ryobi RT101 Operator's Manual page 10

TO ATTACH THE FENCE
See Figure 5.
Follow these directions to attach the fence.
Place the router table right side up with the back
edge closest to you.
Position the fence on the table with the four black
knobs facing you.
Align the two holes on the bottom of the fence with
the two channels on the router table.
Secure the fence to the table with the two fence lock
knobs and carriage bolts.
TO ATTACH THE CUTTER GUARD ASSEMBLY/
VACUUM ATTACHMENT
See Figure 6.
Follow these directions to attach the cutter guard
assembly/vacuum attachment.
Place the router table right side up with the back
edge closest to you.
Screw the guard post securely into one of the
threaded holes on the top of the fence.
NOTE: When the fence is close to the cutter, place
the guard post in the off-center threaded hole to
provide protection from the cutter and allow for proper
suction for the vacuum.
Loosen the clear plastic ring by turning the black
knob counterclockwise.
Slide the ring over the guard post.
Center the cutter guard over the throat of the router
table.
Tighten the cutter guard by turning the black knob
clockwise.
NOTE: While routing, you can insert a standard
shop vacuum into the top of the clear plastic ring to
keep dust down to a minimum.
TO ATTACH THE MITER GAUGE
See Figure 7.
Follow these directions to attach the miter gauge.
Place the router table right side up with the front
edge closest to you.
Place the miter gauge bar in the track near the front
of the table with the pointer on the right.
Position the miter gauge onto the miter gauge bar
placing the miter gauge under the pointer and align-
ing the hole in the miter gauge over the small post in
the miter gauge bar.
Screw the miter gauge knob into the threaded hole
in the miter gauge bar.
ASSEMBLY
10
Fig. 5
Fig. 6
Fig. 7