Verifying Radio Status - HandHeld Dolphin 7900 Series Quick Start Manual

Verifying Radio Status

Dolphin 7900 terminals can be configured with a combination of the following
radios: 802.11b, Bluetooth, and GSM/GPRS (MC-45). Radio drivers install
during the autoinstall process after a hard reset (see
the appropriate drivers for the terminal's radio configuration install.
All radios and radio drivers are co-located inside the terminal. 802.11b and GSM
radios cannot be enabled at the same time. Bluetooth radios can be enabled and
operating with an 802.11b or GSM radio or both.
Radio Manager
The Radio Manager allows you to enable and disable radios installed in the
terminal after initial bootup. If the Dolphin terminal is configured with an 802.11b
radio, the Radio Manager defaults to the 802.11b radio. If the Dolphin terminal is
configured with a GSM radio, the Radio Manager defaults to the GSM radio.
Accessing the Radio Manager
Tap Start > Settings > Connections tab > Radio Manager. The Radio Manager
appears identifying which radio drivers are installed. The highlighted entry is the
radio mode that is currently enabled; its Status should be Ready.
Radio Modes The Radio Modes section lists the radio drivers currently installed
in the terminal.
Status field The Status field displays the status of the radio driver selected in
the Radio Modes section.
Ready - The selected radio is enabled.
Success - The selected radio has been successfully enabled.
Error message - The radio cannot be enabled. You cannot
successfully enable a radio if its driver is not installed.
12 Dolphin® 7900 Series Mobile Computer Quick Start Guide
Autoinstall on page 8). Only