T-Jet SDT-1300 Quick Reference Manual

If you will be transporting your T-Jet 3 from one location to another, or if you will
be shipping it to Equipment Zoe for repair, it is important that you follow the steps
outlined below. Failure to do so culd not only cause serious damage to your T-Jet 3
but may also void your warranty. The preparation process should only take about
10 minutes and if you have any questions regarding any of the steps, please contact
our Support Department.
Installing the Fast T-Jet 3 Cleaning Cartridges
Every Fast T-Jet 3 is shipped with 16 Ink Line Caps. All 16 Ink Line Caps will be
used when exchanging the Bulk Ink system for Cleaning Cartridges. Therefore it is
important to store them in a safe location when they are not being used.
1. Press the Ink button to release
the Print Carriage from
the Capping Station. Then
manually move the Print
Carriage to the center of the
Print Bed.
2. Engage ink line clamps for each ink line and then, one at a time, remove ink
lines from the Bulk Ink cartridges and cap with ink line caps (included).
3. Use the Cartridge Removal Tool and insert it into a cartridge, turn it 90º and
pull the cartridge out. Repeat this process for all eight cartridges. Upon
Fast T-Jet 3 Quick Reference Guide
®

Transporting the Printer

1