Agam AIT 501 User Manual

AIT 501 USERS MANUAL
AIT 501 Smart Digital Insulation Tester
Insulation Resistance Tester
AIT 501 Smart Digital
One-plug
Two-plug
It is recommended to select the specific 8pcs
chargeable batteries (LR14) and a charger.
damaged part,
measurement requirement: Pollution Degree 2,
Overvoltage Category(CAT. III 600V) and Double
Insulation.
alerts the user to avoid electric shock.
affect
1 pc
1 pc
leads and power adaptor with the same
model or identical electrical specifications.
1 pc
1 pc
8 pcs
1 pc
1 pc
1 pc
1 pc
Low Battery Indication
after 15 minutes' inactivity.
There is a battery indicator shown on the upper left
corner of the display. Please refer to Table 3 for
detailed explanation.
almost
necessary. Under this status, the Meter
can still output 500V and 1000V to
measure, the measured accuracy will
not be affected.
When charging battery is applied, the charging battery
work mode should be selected at the startup:
hold USB button prior to startup, then press down ON/
OFF, LCD screen will display CHA or GEN, and select
to display CHA by pressing the up/down key, after
pressing USB key to confirm, the Meter successfully
enters the charging battery work mode. GEN means
the general alkaline battery work mode.
Arrow Button
Arrow Button
Arrow Button
Arrow Button
voltage input terminal
(Connected to two-plug red test lead)
( Connected to two-plug red test lead )
test
(Connected to one-plug black test lead)
(Connected to one-plug test lead)
Two-plug
One-plug
One-plug
Press and
The Meter defaults at 500V range and
under continuous measurement of
insulation resistance when turned on.
LIGHT Press to turn on/off the backlight.
Press to clear the saved data.
value. The Meter can save up to 18 sets.
previous
voltage range.
next voltage
range.
setting the timer for the
When compare function is enabled for
insulation resistance measurement,
values
setting the timer for the
When compare function is enabled for
insulation resistance measurement,
values
Press
measurements
This
The Meter defaults at
500V range and under continuous measurement of
insulation resistance when turned on.