Cautions & Warnings; Compliance Declarations - Delta DNT-T221 Installation Manual

Cautions and Warnings
The DNT-T221 BACstat II is an electrostatically sensitive device. An ESD protection (ground
strap) should be unnecessary if sufficient care is taken in handling because the electronics are
contained within the product housing.

Compliance Declarations

FCC Compliance Information
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Industry Canada Compliance Statement
ICES-003 This Class B digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numérique de la Classe B Respecte toutes les exigences du Règlement sur le matérial
brouiller du Canada.
UL Compliance Information
This product conforms to the following UL requirements:
Document Edition 1.8
• UL916: Energy Management Equipment
• CAUTION – Risk of Electric Shock – More than one disconnect switch may
be required to de-energize the equipment before servicing
• All terminals are acceptable for Class 2 circuit connection only
• CAUTION – Input Class 2 Power Supplies are interconnected. To Reduce
the Risk of Fire or Electric Shock, Use only Class 2 sources Suitable for
Interconnection
• Use Copper Conductor Only
• Select an external power supply that is certified for safety for the correct
destination country and that has an output rating, which is considered an NEC
Class 2 or Limited Power Source with the rating not to exceed 30 V rms, 42.4
V peak, 100 VA.
• Apply minimum 6.0 lb-in torque for tightening field wires into the terminal
blocks.
Delta Controls
Page 9 of 10