Fluidampr 760121 Installation Instructions

2010 & UP GM LS3 & L99 ENGINES
•
Damper removal and installation tools (Kent-Moore J-41816 & J-41665 or equivalent)
•
Anti-seize compound
•
Sufficient torque wrench (see torque specs on page 2)
•
Torque angle meter (Kent-Moore J-45059 or equivalent)
•
Do not use hammers or pry bars to install or remove Fluidampr
•
If installing Fluidampr P/N 760121 with 25% underdrive pulley for 2010-2012 applications, an 81.8" long
accessory drive belt will be needed (Gates P/N K060819). For 2013 & UP applications, a 78" long belt will be
needed (Gates P/N K060780).
•
A new torque to yield crankshaft bolt (GM P/N 12557840) is required and must be obtained at your local GM
dealer.
IMPORTANT – You CANNOT reuse old damper crankshaft bolt.
•
DO NOT DRILL FLUIDAMPR – The inertia ring and silicone fluid are in a hermetically sealed housing.
Part No. Balance
760111 Internal Balance
760121 Internal Balance
BALANCING OR MATCH BALANCING
•
Each Fluidampr component is precision balanced during manufacturing, so NO additional balancing is required.
•
DO NOT ATTEMPT TO BALANCE THE CRANKSHAFT WITH FLUIDAMPR INSTALLED - The inertia ring
inside Fluidampr is balanced to a close tolerance at the factory and it rotates inside Fluidampr.
•
If balancing the crankshaft is required, install the stock damper while balancing.
•
Remove any equipment or accessories obstructing access to the stock damper per manufacturer's instructions.
•
Remove the accessory drive belt and A/C compressor drive belt.
NOTE - There is no tensioner on the A/C belt. The belt will either have to be "walked" off of the pulley or cut and
replaced with a new belt.
•
Remove the stock damper using a suitable puller. Save the stock damper crankshaft bolt to use during the
Fluidampr installation process.
•
On the rear of the stock damper hub you will find a thin metal washer held in place with a rubber gasket. This
washer will need to be removed and installed on the Fluidampr. If you don't have a washer or the one you have is
destroyed one can be obtained thru your local GM dealer (ref GM P/N 12603843).
P/N 760111 With Stock Pulley
Tools, Procedures, & Accessories
Notes On Balancing
Application
Chevrolet Camaro LS3 & L99 Stock Pulley
Chevrolet Camaro LS3 & L99 25% Underdrive
Step 1 – Stock Damper Removal

Installation Instructions

P/N 760121 With 25% Underdrive Pulley
Year
2010 & UP
2010 & UP