INSTALLATION, OPERATION &
MAINTENANCE DATA SHEET
FOR
KF1L SERIES LED LUMINAIRE FLOOD
CLASS I DIVISION 1, CLASS II DIVISION 1, OR CLASS I
ZONE 1 HAZARDOUS LOCATIONS.
KF1L SERIES LED LUMINAIRE FLOOD
CAUTION:
Before installing, make sure you are compliant with area classifications, failure to do so may result in bodily
injury, death and property damage. Do not attempt installation until you are familiar with the following
procedures. All installation must comply with the applicable Electrical Code.
Make sure that the circuit is de-energized before starting installation or maintenance.
Verify that the installation is grounded. Failure to ground will create electrical shock hazards, which can cause
serious injury and or death.
Note: Due to the surge protection provided in the fixture to protect the internal electronics and LEDs, a branch
circuit with the LED fixture may false fail a megohmmeter test (sometimes referred to as a megger test. If a
megohmmeter test is required, the LED fixture should be removed from the branch circuit.
Note: Multiple fluorescent or LED fixtures attached to a single Ground Fault Circuit Interrupter (GFCI) may
cause nuisance tripping of the GFCI. Regulatory agencies allow a small amount of leakage current because
of the circuitry required to mitigate possible issues with electromagnetic compatibility (reference UL8750 and
EN61347). The summation of these leakage currents from multiple fixtures may be enough to trip a GFCI.
IMPORTANT:
Please read these instructions carefully before installing or maintaining this equipment. Good electrical
practices should be followed at all times and this data should be used as a guide only.
Technical information, advice and recommendations contained in these documents is based upon information
that Killark believes to be reliable. All the information and advice contained in these documents is intended
for use only by persons having been trained and possessing the requisite skill and know-how and to be used
by such persons only at their own discretion and risk. The nature of these instructions is informative only and
does not cover all of the details, variations or combinations in which this equipment may be used, its storage,
delivery, installation, check out, safe operation and maintenance. Since conditions of use of the product are
outside of the care, custody and control of Killark, the purchaser should determine the suitability of the product
for his intended use, and assumes all risk and liability whatsoever in connection therewith.
3940 Dr. Martin Luther King Drive
St. Louis, MO 63113
P/N KIL00921415 FORM NO. K1415 7/13 ERO-6-019-13_2
Page 1 of 8
Need help?
Do you have a question about the KF1L SERIES and is the answer not in the manual?
Questions and answers