Coopers Key Finder Instructions For Use

Remote key finder

Remote Key Finder

Please read and retain these instructions for future reference

PLEASE SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

USER INSTRUCTIONS:

Switch on the receiver and slide to change from OFF to ON (key tag). It will beep continuously. Push

button as indicated by "Press" on the side of the card, the receiver will emit a short beep once and

will then stop beeping which means the receiver (key tag) and card are matched.

Please push the button again if they are not matched at the first attempt.

Fit your keys to the matched key tag and put the card into your wallet or handbag. When you can't

find your keys, just push the button on the side of the card, the key tag will beep for 5 seconds then

stop automatically. You can push it again and again until you find the lost keys.

1x CR-2032 and 2x CR-2016 batteries are included.

1. Receiver: When the receiver sounds a low and strange beeping, it means the battery is low.

Insert a new CR-2032 button battery. Observe polarity, the "-" face down to the PCB board.

2. Card: When you push the card's button, but the receiver shows no reaction, and you can't

see a red light at the hole on the the card's back, then battery power is insufficient. Pull out

the battery drawer at the other side of the card, change the battery with 2 pcs of CR-2016

battery, and make sure both the 2 pcs "+" face the back of the card.

My key finder cannot be matched

Your card's battery may not have enough power, make sure the card's red LED is on when you are

pushing the card's button, and match the receiver (key tag) with the card at 0.5 metre distance.

My key tag beeps continuously

The key tag will beep continuously before it is matched. The key tag will beep continuously, if you

keep pushing the card, so please don't push the card after you find the keys. It will stop beeping

automatically 5 seconds later.

I pushed the button on the card, and the LED is working, why I can't find the keys?

The keys may not be in this room, please try other rooms. And make sure it is matched before you

use it.

10874

Instructions for Use

v001: 15/05/17

Table of Contents

Do you have a question about the Key Finder and is the answer not in the manual?

Page 1 2 pcs “+” face the back of the card. Troubleshooting My key finder cannot be matched Your card’s battery may not have enough power, make sure the card’s red LED is on when you are pushing the card’s button, and match the receiver (key tag) with the card at 0.5 metre distance.
Page 2 Remote Key Finder Instructions for Use 10874 Please read and retain these instructions for future reference v001: 15/05/17 My key tag is beeping very strange, why? It may be lacking power, please change the battery. Remarks: Never push the button while on an aircraft.