STEIN RGK26 Series User Instructions

Ridgegear recommends this product undergoes an in-depth inspection before it is used, periodically during use, and after each use. Do not hesitate to retire a product showing signs of wear which
might affect the strength, or restrict its operation. For your own safety we advise you adopt an inspection criteria for this product by a competent person. If you are not able, or not in a position to
Product Information
PART NUMBER
Serial Number
Purchase Date
Date first used
Purchased from
Comments
STEIN
Ridgegear
Date
Part Number (P/N)
Serial Number (S/N)
Instructions for maintenance
(1) The equipment may be cleaned with a mild detergent not exceeding 30
warm water.
(2) Allow to dry naturally away from direct sources of heat. Rinse and/or wipe off any build up of dirt and grit.
(3) Store in a clean, dry area and away from direct source of heat or sunlight, or any potentially sharp or abrasive objects
such as knives or tools.
Periodic examinations and service
(1) Before every use, the user shall inspect the equipment following the inspection guidelines below.
(2) The safety of the user depends upon the continued efficiency and durability of the equipment, therefore an additional
thorough periodic inspection is required by an independent competent person familiar with inspecting this type of
equipment.
(3) The frequency of examination and inspection must take into account legislation, equipment type, frequency of use
and environmental conditions. Through examinations must be carried out by a competent person every 6 months and
the results and date of the inspection must be recorded.
(4) The equipment must be totally replaced after a maximum of 5 years after the date of first use.
Inspection
Webbing - check for cuts, tears, abrasion, scorch marks, burns, chemical attack or severely discoloured patches.
·
Local abrasion, distinct from general wear is often caused by passage of the webbing over sharp and/or abrasive
edges, and may cause serious loss of strength. Slight damage and scuffing to outer fibres may be considered safe,
however more serious levels of abrasion and reduction in width or thickness or serious distortion of the weave pattern
must lead to immediate rejection.
· Stitching - check for broken, loose, worn or abraded stitches or severely discoloured patches to the stitching. Reject
if present.
Product marking – check that the product markings including the serial number are legible. Reject if they are not.
·
Modification & repair
(1) This equipment must not be modified or repaired unless advised by us in writing. Only competent persons authorised
by us may carry out any repairs. If in doubt contact Ridgegear for further advice.
Records
(1) When using the equipment for the first time, ensure that the first part of the product record card is completed and the
date of first use is recorded.
(2) Ensure that the equipment is inspected at regular intervals dependent upon frequency of use. Details of all
inspections must be recorded in the spaces provided on the record card.
(3) It is essential for the safety of the user that if the product is resold outside the original Country of destination that the
reseller shall provide instructions for use, for maintenance, for periodic examination and for repair in the language of
the Country in which the product is to be used.
assume this responsibility, seek professional advice.
Date Reason for entry
Issued to User
Explanation of Product marking
Brand name
Manufacturer
Date of manufacture
Product part number
Unique traceability number
PERIODIC EXAMINATION RECORD
Examination Notes
Add Users Name Here
RGK26 /
letter
BSEN 795:2012 Type B
BSEN 566:2006
Book symbol
CE 0086
° C, and must be rinsed afterwards in clean
Name signature
Product description
EN Standard the product conforms to
EN standard the product conforms to
Warning to read the user instructions
Article 11b approving body
User Instructions for
STEIN Webbing Slings
15mm SLING 22kN
These products are manufactured from manmade fibres typically nylon,
polyester and UHMWPE
www.steinworldwide.com
Please read these instructions thoroughly
before using this equipment