Inter-fab TANNING LEDGE TABLES Assembly/Installation Instructions

For gunite retrofit/aftermarket. 30 inch table w/umbrella hole

Advertisement

T NNING LEDGE T BLES
ssembly & Installation Instructions
W RNING: IMPORT NT INST LL TION INFORM TION
The installation of this product should be done only by a licensed and professional installer. Installation should
be done strictly in conformance with all local building codes, electrical codes and other building and safety laws
and regulations. Among other things, that your installer should carefully analyze the need to bond the product
to prevent an electrical hazard. Failure to properly install this product could result in a dangerous condition,
including but not limited to electrical or structural hazards. Inter-Fab, Inc. disclaims all liability arising from the
installation and the user assumes all risk associated with the installation.
I N T E R - F B , I N C . 3 0 5 0 S .
5 2 0 . 7 9 0 . 7 0 4 0 • 8 0 0 . 7 3 7 . 5 3 8 6 • F X 5 2 0 . 7 9 0 . 7 1 2 7 • i n t e r - f a b . c o m
Retrofit_Table-IM Rev. 5/15
FOR GUNITE RETROFIT/ FTERM RKET
30" Table w/Umbrella Hole
L V E R N O N W Y • T U C S O N ,
INST LLS IN
3 E SY STEPS!
1.
2.
3.
Z 8 5 7 1 3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TANNING LEDGE TABLES and is the answer not in the manual?

Questions and answers

Summary of Contents for Inter-fab TANNING LEDGE TABLES

  • Page 1 Failure to properly install this product could result in a dangerous condition, including but not limited to electrical or structural hazards. Inter-Fab, Inc. disclaims all liability arising from the installation and the user assumes all risk associated with the installation.
  • Page 2 I N S T T I O N M R E T R O F I T T B L E S INTENDED USE INSTRUCTIONS Everyone who uses this Table must understand and follow these instructions. If installed in a pool with diving equipment or a pool slide, the table installation must not interfere with the diving or sliding safety envelope.
  • Page 3 I N S T T I O N M R E T R O F I T T B L E S SSEMBLY & INST LL TION INSTRUCTIONS FOR T BLES: 1. Locate the support pole receiver. NOTE: white internal ring end gets glued into table flange. See Figure 2. 2.
  • Page 4 Inter-Fab, Inc., and expressly does not cover any labor or reinstallation expenses related to the replacement of any and all Inter-Fab products. This limited warranty shall be the sole and exclusive remedy of irrespective of whether the claims are made in contract, tort, warranty, law, equity or by statue.

Table of Contents