MAXSA 43319 Assembly And Instruction Manual

ASSEMBLY AND INSTRUCTION GUIDE
Model #s 43319, 44219, 46219, and 48219
ABOUT YOUR LED OUTDOOR WALL SCONCE
The LED Outdoor Wall Sconce is perfect for porches,
doorways, or around the house.
The LED Outdoor Wall Sconce has a built-in motion sensor,
which automatically turns on the light when movement of a
heat source (such as people, animals, or cars) is detected in
the area. The light remains on while motion continues to be
detected in the area.
The LED Outdoor Wall Sconce also has a built-in photosensor
so that the light only turns on at night.
The LED Outdoor Wall Sconce may function irregularly or not
at all at temperatures below 0°F / -17.8°C. Normal operation
will return when the temperature rises.
The LED Outdoor Wall Sconce requires 4 C cell batteries (not
included). The batteries typically last up to 1 year under
normal use.
The 2 super bright Surface Mount LEDs in the LED Outdoor
Wall Sconce produce a warm white light (~3000K) and have
an estimated life of 30,000 hours. The LEDs should never
need changing.
CHOOSING A LOCATION
The selected location should not be near light sources such as
street or porch lighting as these may cause the LED Outdoor Wall
Sconce to turn off automatically. The LED Outdoor Wall Sconce
should also be installed away from heaters, air conditioners,
barbecues, vents, large reflective surfaces such as swimming
pools and jacuzzis, and white walls.
You should also install the LED Outdoor Wall Sconce at least 30
feet away from the street, so the light is not activated by passing
cars.
30 feet or more from street
CHOOSING A LOCATION, CONTINUED
Ideally, the LED Outdoor Wall Sconce should be mounted with the
detector at the height of or above the objects to be detected.
23
feet
The motion sensor has a dectectable area of about 23 feet (7
meters) within a 100 degree angle of the sensor. The sensor is
more sensitive to movement across the detection area than
movement directly towards or away from the sensor.
At night, the LED lights will remain on for approximately 30
seconds after the last detected movement. If a movement is
detected while the lights are on, the light duration will be reset and
will remain on for an additional 20 seconds (approximately).
NOTE: Do not mix old and new batteries. Do not mix alkaline,
standard (carbon-zinc), or rechargeable (Nickel-Cadmium)
batteries.
90
Degrees