SMART-AVI HDC-400 User Manual

Technical Specifications

HDC-400 Specification
Max Distance 1,000 feet
Format RGB, YUV, Y/C, CVBS
1 volt p-p, 75 Ohm
Resolution Up to 1900 x 1200
Supported Signals YPbPr, Y/C, composite video, stereo
audio
Video Amplifier Bandwidth 300 MHZ
Audio Frequency Response 20 Hz to 20 kHz
Supported Resolutions 480p, 720p, 1080i, 1080p
Connectors Three female RCAs for video and two
female RCAs for audio
Cable Cat 5, Cat 5e, Cat 6, Cat 6e
RS232 DB9M, TXD, RXD, Gnd., 9600 bps
Enclosure Metal
Dimensions
Power 5 VDC @ 2 A
Shipping Weight
Operating: 32 to 131 degrees F
Storage: -4 to 185 degrees F
Humidity: up to 95%
Warranty 2 years
Compliancy CE, RoHS
Sending an RS-232 command to remote monitor
In order to send a command to a remote monitor, you
will need to use The following query at 9600 baud
rate;
<CR>//M1<CR>
After sending this query, any command sent from
the PC will go directly to monitor 1
To send a command to monitor 2 replace "M1"
with "M2" etc...
To send the same command to all monitors ( but
only monitor 1 will answer) Use the following
command;
<CR>//M0<CR>
* <CR> = Carriage return
Notice
The information contained in this document is
subject to change without notice. Smart-AVI, Inc. makes
no warranty of any kind with regard to this material,
including but not limited to, implied warranties of
merchantability and fitness for any particular
purpose.
Smart-AVI will not be liable for errors contained herein
or for incidental or consequential damages in
connection with the furnishing, performance or use
of this material.
No part of this document may be photocopied,
reproduced or translated into another language with
out prior written consent from Smart-AVI.
User Manual
HDC-400
Use Cat5 Cabling to Broadcast
High-Resolution Component Video,
Stereo Audio, RS-232 and Infrared
to Four Stations up to 1,000 Feet Away