Might-D-Light LED150 Instruction Manual

USING BOTTLE OPENER
Bottle opener may be used to open most metal capped bottles.
1. Angle worklight so that the bottom edge of the bottle opener lifts the bottom edge of the bottle cap (Fig. 1).
2.
Lift worklight up to pry bottle cap off.
3. Wipe clean any residue left on worklight with dry or damp clean cloth.
ATTACHING LANYARD
1. Remove lanyard from packaging.
2.
Thread short loop behind lanyard pin and
insert wrist strap into short loop. Pull until
short loop is snug against lanyard pin (Fig. 2).
3. Lightly pull on lanyard to verify attachment.
MAINTENANCE
Before performing any maintenance, ALWAYS unplug worklight. Remove dirt and grime as soon as it accumulates. Use
a soft, damp cloth and a mild soap, if needed. Be sure not to get the electrical lug wet. NEVER submerge any part of the
worklight in any solution to clean it. DO NOT USE solvents such as gasoline, turpentine, etc. to clean unit. Aerosols and
other chemicals may fog the clear polycarbonate lens.
ONE YEAR FULL WARRANTY ON WORKLIGHT
f this product fails due to a defect in material or workmanship within one year from the date of purchase, RETURN IT
I
TO YOUR NEAREST STORE IN THE UNITED STATES, and it will be replaced free of charge. This warranty applies for only
90 days from the date of purchase if this worklight is used for commercial or rental purposes. This warranty gives you
specific legal rights, and you may also have other rights, which vary from state to state.
Eaton's Cooper Lighting Business
• 1121 Highway 74 South, Peachtree City, GA 30269 • www.eaton.com © 2014 Eaton
Fig. 1 Fig. 2
Printed in China 09/14 825-1020
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS!
DANGER
- TO REDUCE THE RISK OF ELECTRIC FIRE OR ELECTRIC
SHOCK, CAREFULLY FOLLOW THESE INSTRUCTIONS.
WARNING
- When using electrical fixtures, base precautions
should always be followed, including the following:
1. Read all instructions before using the fixture.
2. DO NOT handle this fixture or try to plug it in when your
hands are wet or damp or when you are standing on a wet
or damp surface or in water.
3. To reduce the risk of injury, close supervision is necessary
when an fixture is used near children.
4. ONLY USE attachments recommended or sold by the manufacturer.
5. DO NOT use outdoors. This fixture is intended for use as general indoor lighting.
6. DO NOT use in potentially dangerous locations, such as flammable or
explosive atmospheres.
7. To reduce the risk of electric shock, do not put in water or other liquid.
Do not place or store fixture where it can fall or be pulled into a tub or sink.
Instruction Manual
LED WORK LIGHT
MODEL NO.
LED150 / LED150C