Yamaha YFM45FAT Supplementary Service Manual page 56

REAR CONSTANT VELOCITY JOINTS, FINAL DRIVE
1
GEAR AND DRIVE SHAFT
2
– 48 –
3. Install:
• universal joint yoke
• washer
• nut 1
97 Nm (9.7 m · kg, 70 ft · lb)
NOTE:
Use the universal joint holder 2 to hold the
yoke.
Universal joint holder
P/N. YM-04062, 90890-04062
4. Install:
• drive shaft assembly
M MMM M MMM M M MMM M
a. Install the opposite yoke into the U-joint.
b. Apply wheel bearing grease to the bearings.
c. Install the bearings 1 onto the yoke.
CAUTION:
Check each bearing. The needles can eas-
ily fall out of their races. Slide the yoke
back and forth on the bearings; the yoke
will not go all the way onto a bearing if a
needle is out of place.
d. Press the bearings into the U-joint using a
suitable socket.
NOTE:
The bearing must be inserted far enough into
the U-joint so that the circlip can be installed.
e. Install the circlips 2 into the groove of each
bearing.
L LLL L LLL L L LLL L
DRIV
M MMM M M MMM M M MMM M
L LLL L L LLL L L LLL L
MMM
LLL