Advertisement
KNOW YOUR ELECTRIC KETTLE
Kettle lid
Body
BEFORE USING YOUR KETTLE
If you are using the kettle for the first time, it is recommended that you should clean your kettle before
use by boiling with Max. capacity of water and then discarding the water. Repeat this process twice. Wipe
the surface with a soft damp cloth.
NOTE: The Max. capacity of the kettle is 1.7L.
USING YOUR ELECTRIC KETTLE
1.
Place the kettle on a flat surface.
2. To fill the kettle, remove it from the power base and open the lid by pressing down on the lid release
button, then fill the kettle with the desired amount of water and close the lid. The water level must be
within the Min. (0.7L) and the Max. (1.7L) level marks. Too little water will cause the kettle to switch
OFF before the water has fully boiled.
NOTE: Do not fill the water over the Max. level mark, as water may spill out of the spout when boiling.
Ensure that the lid is firmly in place before connecting to mains power.
3. Position the kettle on the power base.
4. Connect the supply cord plug into a mains power outlet. Press down the power switch on the kettle and
the indicator will light up, and the kettle will start to boil the water. The kettle will switch OFF
automatically once the water has fully boiled. Please note, it will take approximately 30 seconds to
Spout
Lid release bottom
Handle
Water level gauge
Switch
Power base
4
Advertisement
