Viking VK75 P Instructions

Viking VK75 P
75w Led Moving
Light
Instructions
This Profile Led Moving Spot is designed to create gobos & colour patterns & in air
effects using DMX control from a lighting desk or sound activated stand alone displays.
Hang the fixture using the clamp provided plus a M10 bolt set & Standard Hook Clamp,
or stand the unit on a convenient surface without using any of the above.
DMX is daisy chained in and out of the unit using 3 pin XLR and power is connected
via the supplied Powercon mains lead with blue Connector. The unit is fitted with an
external 3a 20mm fuse for easy replacement and to protect the unit & electronics from
mains surges.
The LCD Display is used to alter settings including the DMX Address using the Menu,
up, down and enter buttons, while the Menu button is used to select the feature to be set.
The Unit has a sophisticated service facility built in which is also accessed via these
menu options and can be ignored by the end user.
Power Up:
On turning on the power the unit will briefly perform a self check and will display
while the system is checked. On Completion the unit will display
RST 00XX
the current DMX address
Wait ....
(called the home message)
LCD Display Settings:
When the unit is displaying the DMX address pressing the MENU button will prompt
for the DMX, pressing UP or DOWN buttons at this time will cycle through the options
RUN ADDRESS EDIT SPECIAL GENERAL To select any of these press ENTER
ADDRESS
VIKING
ADDR:001
Setting DMX Address:
Press Menu when on the above screen and ADDRESS will appear - if it doesn't then
cycle through the options using Up and Down buttons unit it does. Pressing ENTER
will display the current setting and allow it to be altered with the Up and Down buttons.
When correct, to store this new DMX value press ENTER, the value will stop flashing
and is then stored. Press ENTER twice to return to the main menu again
VIKING
ADDR:001
GENERAL
Under this menu you can adjust the following options:
Used for service, this shows the hours the unit has been
GENERAL
turned on and also LED usage (shown only when Service
Light
password has been entered.
Used to reverse or normalise Pan or Tilt functions. Select option
GENERAL
and adjust setting using Up Down and Enter. Exit by pressing
INVERT
Menu until the home message is displayed.
Used to either set the LCD display to turn off after 60 seconds
GENERAL
of inactivity or to always be on. Select the function required
LCD. Disp
as above options
Used to select the sensitivity of the inbuilt microphone used to
GENERAL
trigger the sound activated response of the unit. Value is from
SOUND
001-255 and adjusted as the above functions.
Used to reset the unit to factory defaults including DMX
GENERAL
address & functions
DEFAULT
This option is used to reset the head entirely or just a particular
SPECIAL
function if it is incorrectly responding. This retains the DMX
address. Other options under this heading are for service only
This option is used to select a mode of operation. Once selected
RUN
the unit will boot into this mode on power up automatically .To
alter scroll through options using UP Down buttons & Enter to
select. The Mode is shown in the home message on power up.
Options are:
RUN
RUN
Test : for service use only.
Test
DMX512 : Select this to use on a lighting desk or other DMX
RUN
control equipment
DMX512
AUTO1 & AUTO2 : Select for inbuilt simple demo programs.
RUN
Auto1 is quick moving and Auto 2 is a slow moving demo.
Auto1
SOUND : Select for sound activated movement & the head will
RUN
change gobo, location, colour and other parameters on a beat in
Sound
music. Use with GENERAL SOUND sensitivity setting.
RUN
SLAVE : Select when linking multiple units together so this
Slave
unit will replicate the unit being used as master.
M81