Safety Notice Prior to riding the Black Hawk Electric Skateboard, it is important to read through this user manual. All instructions and warnings should be followed to ensure safe operation. Proper judgement and sensible operation should be applied at all times when operating the electric skateboard. This device uses brushless hub motors to accelerate and brake while in operation.
See below the breakdown of all components: E – Rear Wheels A – Front Wheels F –Battery B – Front Trucks G – On/Off Switch C – Deck H – Charge Port (on other side) D – Rear Trucks Black Hawk Electric...
Charging Charging of your electric skateboard is made simple thanks to an intelligent smart-charger and an on-board Battery Management System, (BMS). When charging it’s important to connect the charger and charger cord to the power outlet, (wall socket) before connecting to the skateboard.
(Speed Mode 1). Then in the second setting the skateboard operates the advanced mode, (Speed Mode 2). We recommend the use of Modes Speed Mode 2 in wide open spaces. Black Hawk Electric...
You can ride in two different stances as shown below: Balance This electric skateboard uses a powerful motor which can throw you off balance when accelerating and also decelerating. It is important to pre-empt these forces and counteract the propulsion and/or the slowing-down of the skateboard.
- Avoid shared traffic conditions with other motor vehicles For more information on what the skateboard is capable of and warranty terms for please visit the warranty information on page 14 of this user manual or on our website at: blackhawkelectric.com.au Black Hawk Electric...
- Never work on the skateboard when it is plugged into AC power source. You may risk serious injury from electric shock as well as damage to the skateboard. - The cells within the battery contain toxic substances.
Page 10
Continued… Battery Safety - Only use chargers supplied and approved by Black Hawk Electric and never attempt to bypass or override the protection circuits. - Do not attempt to wash the skateboard with water or high- pressure water washers. - Avoid getting water near or into the charge port.
Component Removal Whilst removing any components without permission from Black Hawk Electric may void your warranty, replacing a wheel/tire or removing a truck is made simple with easy to access fixings just as the axles and wheel mounts shown below.
The grip tape used on the skateboard is tough wearing however it is expected to wear and decrease in grip with usage of the board. We recommend mounting and dismounting the skateboard without ‘scrubbing’ the grip tape too much to extend its lifetime. Black Hawk Electric...
Hill Gradient Up to 10% Weight 5.5kg Charging 3 Hours Warranty 12 months Deck Length 90cm 2.5” Wheels Trucks Aluminium Remote Ergonomic Bluetooth Remote Weight Limit 90kg Charge Time 3 Hours Intended Usage Recreational Use Age Limit Black Hawk Electric...
If the product is proved faulty under normal usage, Black Hawk Electric will at it’s discretion: - Repair the product by means of email support with supplied photos and/or footage to demonstrate the fault or issue from the customer.
Need help?
Do you have a question about the Electric and is the answer not in the manual?
Questions and answers