USE OF THIS PRODUCT IN A COMMERCIAL TANNING FACILITY OR FOR PROFESSIONAL AND MEDICAL SERVICES AUTOMATICALLY RESULTS IN THE VOIDING OF ANY AND ALL MANUFACTURER’S WARRANTIES! THIS PRODUCT IS IN CONFORMITY WITH PERFORMANCE STANDARDS FOR SUN LAMP PRODUCTS UNDER U.S. FDA SECTION 21 CFR PART 1040.20. www.mercola.com...
Lamp Cleaning and Replacement How to Obtain Service Helpful Service Hints Lamp Configuration Frequently Asked Questions Photosensitivity Pregnancy Record Your Warranty Information General Specifications/Size Chart Warning Label Information Please read entire manual before attempting to operate this tanning unit! www.mercola.com...
Tanning Bed Specifications/Info Dedicated Weight Voltage Size Amps NEMA Fans Timer* Breaker Receptacle (lbs.) (Volts) HxWxL” (Rated) Amps 28x32x76 5-15R Mechanical This tanning system comes equipped with an internal backup timer. Refer to Table of Contents for more information on timers. www.mercola.com...
Failure to comply with these electrical requirements will VOID ALL WARRANTIES and will damage electrical components! WARNING: HIGH LEAKAGE CURRENT – ENSURE PROPER GROUNDING. WARNING: GROUNDING CIRCUIT CONTINUITY IS VITAL FOR SAFE OPERATION OF EQUIPMENT. NEVER OPERATE WITH GROUNDING CONDUCTOR DISCONNECTED. www.mercola.com...
Page 6
SERVICE AND MAINTENANCE HINTS IN THIS USERS MANUAL… IF YOU HAVE ADDITIONAL QUESTIONS… REQUIRE TECHNICAL SUPPORT… INTERESTED IN PURCHASING TANNING ACCESSORIES…OR FUTURE UPGRADES FOR NEW LAMPS… DO NOT HESITATE TO CONTACT THE AUTHORIZED DEALER WHERE YOU PURCHASED YOUR TANNING BED. www.mercola.com...
(Proper assembly of your tanning bed requires two people.) Tools required – Assembling the tanning bed requires a ½ inch wrench Parts List Item Description Quantity Left Arm Right Arm Bench Leg Gas Shocks 5/16 x 1 ½ Allen Bolt Allen Wrench Pedestal www.mercola.com...
Page 8
Use the allen wrench (I) to tighten. Step 2. Turn bench right side up on floor. Place so that the power cord connection is facing your wall outlet. www.mercola.com...
Page 9
Slip the allen bolt (E) through the aligned holes. Tighten bolt with the allen wrench. To avoid damaging the threaded inserts, do not over tighten. Do NOT lower canopy until both gas shocks have been installed www.mercola.com...
Page 10
Step 2. Lift the canopy to the maximum open position and snap the ball end socket onto the bottom ball end of the bench by pushing into place. Repeat for the second gas shock. www.mercola.com...
Page 11
3 wire extension cord of at least # 12 gauge wire for under 12 feet. If longer than 12 feet, then you will need a 3 wire 10 gauge extension cord. (good to 25-30 ft.) AS RECOMMENDED FOR ALL ELECTRICAL APPLIANCES, THIS TANNING BED SHOULD NEVER BE OPERATED NEAR WATER OR WHILE YOU ARE WET. www.mercola.com...
Not recommended for tanning! II. Light: burns easily and severely, tans minimally III. Normal: burns moderately, tans average IV. Dark: burns minimally, tans easily and above average MAXIMUM EXPOSURE TIME IS 10 MINUTES ALLOW 48 HOURS BETWEEN ALL TANNING SESSIONS! www.mercola.com...
Caring For and Maintaining Your Tanning Bed THE TANNING BED SHOULD BE COMPLETELY SHUT DOWN AND UNPLUGGED FROM POWER SOURCE AT LEAST TWO (2) FULL HOURS BEFORE ANY CLEANING OR MAINTENANCE TO ALLOW THE TANNING BED TO ADEQUATELY COOL DOWN!!!! www.mercola.com...
Electric Beach , available at your authorized dealer. Products not approved for indoor use will break down the acrylic. • In order to keep the acrylic from being scratched, jewelry should not be worn while tanning. www.mercola.com...
For lamp replacement, refer to “Lamp Cleaning” section to follow. Lamps used longer than 1000 hours have lost their tanning power even though they will continue to light. www.mercola.com...
Authorized Dealer where the bed was purchased. If it becomes necessary to replace a warranty part, proof of purchase is required to obtain warranty service. It is important to keep your store receipt. For non-warranty parts replacement or for routine maintenance, contact your Authorized Dealer. www.mercola.com...
Contact your Authorized Dealer other are not lit for replacement assistance. Canopy fails to stay Double check assembly instructions. Gas shocks may have in the upright been put on upside down. See page 10. position www.mercola.com...
UV rays. It’s dryness to the skin or reactions to cosmetics, medications or foods that may contribute to this. If a medication, irritation, cosmetic or food is causing the rash, you should stop tanning until the rash disappears. www.mercola.com...
• Herpes Simplex • Lupus Erythematosoyus (swelling of the nerve endings) • Porphyria-severe (extreme sensitivity to any source of light) • Vitiligo (irregularly shaped patches of skin with no pigmentation and dark borders) • Skin cancers (Basal, Squamous, and Melanoma) www.mercola.com...
Birth Control Pills Diabetes Drugs Diuretics Psoralen Drugs (topical or oral) Tranquilizers/Antipsychotic Drugs For more information on photosensitivity, please see the following websites: http://www.fda.gov http://www.emedicine.com http://www.intelihealth.com http://www.lupus.org http://www.photosensitivity.org Pregnancy You should consult with your doctor before tanning while pregnant. www.mercola.com...
Page 21
SERVICE AND MAINTENANCE HINTS IN THIS USERS MANUAL… IF YOU HAVE ADDITIONAL QUESTIONS… REQUIRE TECHNICAL SUPPORT… INTERESTED IN PURCHASING TANNING ACCESSORIES…OR FUTURE UPGRADES FOR NEW LAMPS… DO NOT HESITATE TO CONTACT THE AUTHORIZED DEALER WHERE YOU PURCHASED YOUR TANNING BED. www.mercola.com...
Receptacle Voltage* 120V 60Hz Minimum Room Size 8’ x 8’ x 8’ Maximum Ambient Room Temperature Lamp Hours 1000 *Refer to Electrical Requirements. (See Table of Contents.) Size Chart Height Height Width Length Open Closed “W” “L” “H1” “H2” www.mercola.com...
IV. Dark: burns minimally, tans easily and above average MAXIMUM EXPOSURE TIME IS 10 MINUTES Disconnect power cord before attempting to clean, re-lamp, or engage in the maintenance of this product. Made in the USA Copyright 2013 03/15/13 Item #660017 rev.H www.mercola.com...
Need help?
Do you have a question about the Vitality D-LITE and is the answer not in the manual?
Questions and answers