Niigata seiki PICK-MARKER AP-03 Instruction Manual

Pneumatic Engraving Perforator
PICK - MARKER
Thank you for purchasing the Niigata Seiki Pneumatic Engraver.
Connected to an air compressor, the engraver is ideal for precision engraving work on a wide range of material, including
molds and tooling, cutlery, glass, etc. Tool is also well suited for casting shakeout operations.
●
For safe and proper use of this product, please read this instruction manual before use and follow the procedures described.
Please keep manual where it is accessible to user for future reference.
●
Keep this manual with the instrument if transferred or leased to a third party.
●
For inquiries about this product, please contact dealer or place of purchase.
■PART IDENTIFICATION and FUNCTION
③ Collar ②Main Body
①Stylus
COMPATIBLE MATERIALS
Materials listed as compatible may not give satisfactory results depending on surface treatment, thickness, etc.
Always test material first in an inconspicuous area.
... Can be engraved
... Incompatible
※Hardness HV510 or below
SAFETY PRECAUTIONS
Always follow these marked operating procedures in order to prevent
harm to yourself or others, and to prevent damage to property.
CAUTION
Read this manual and follow the instructions.
・Use of product other than as described in the manual
may cause accident.
Use only for fine work on approved materials.
・Use other than as specified may cause product wear
or damage, or a failure in an unpredictable manner.
Do not modify.
・Modification of product may cause damage, accident,
or injury. Do not modify under any circumstances.
Always wear work gloves.
・Workpiece may fail while being engraved and cause
injury.
Do not contact Stylus with skin or person.
・Use care when handling as the Stylus is sharp.
④ Valve
⑤ Air Hose
⑥Quick Connect Plug
( Nipple )
Plastic Glass Non-Ferrous Metals
Improper use may result in
①Stylus ･･･････････････
②Main Body ･･･････････
③Collar ･･･････････････
････････････････
④Valve
･････････････
⑤Air Hose
⑥Quick Connect Plug
( Nipple )
⑦ Gasket ・ O-Ring
Iron Hardened Steel
Please Observe
Denotes a prohibition-
You MUST NOT do
personal injury or damage to property .
Do not touch Stylus while connected to Air Supply.
・When air is connected, Stylus moves very fast, over
500 cycles/sec. Never touch the Stylus when air is
connected.
Work piece should be firmly secured, and operator
position should be stable.
・To insure that the Stylus does not slip and to avoid
injury, make sure operator has a stable position and
that workpiece is secure.
Handle with care.
・Do not drop or subject to excessive shock. Do not
place under heavy objects. Improper handling may
cause damage.
Disconnect air supply to inspect or service
instrument.
・Always disconnect air supply when inspecting or replacing
parts to prevent dangerous, unexpected operation.
INSTRUCTION MANUAL
Model No.
Engraving tip.
This is a consumable item, please
replace with new Stylus when worn.
Grip for holding the tool.
Supports the moving Stylus.
Lubricate with one ( 1 ) drop of oil
daily.
Valve for turning on the
compressed air to the engraver.
Amount of air flow can also be
adjusted.
Compressed air hose.
Length:approx. 3m.
･･･
For connection to compressed air
supply coupler. ( Air compressor. )
･････
Replacement internal parts for
preventing air leaks.
※
Stainless Steel
Denotes a requirement-
You MUST do
AP-03
Tungsten Carbide