Serene House Cube Instruction Manual

Instruction Manual
Product & Accessories
Cube（121202001 White / 121202002 Black）
• Please check if all following items are present and if there is any damage before use.
Lid（ON / OFF）
Nozzle
Main unit
Micro USB power socket
Spray setting button /
indicator light
Water tank opening Rubber Cap
Lid
Water tank

Operating Instructions

• Always place your scent diffuser on a firm, flat, and level surface.
1
2
3
1
Cube
Scent Diffuser
4
5
（Back）
6
7
Micro USB cable
Press the lid downward gently; the lid will automatically
rise upward shortly.
Remove the lid once the lid is in its raised position.
Turn the lid upside down; the water tank is located
underneath it. Open the rubber cap on the water
tank opening.
2
Fill the water tank with SERENE HOUSE Fragrance
Aqua of your choice to 80% full and close the rubber
cap.
• Do not fill the water tank with SERENE HOUSE
Fragrance Aqua exceeding the surface of the water
tank; this is to avoid affecting its operating efficiency.
• Fragrance Aqua is sold separately and is not
included with the product.
Put the lid back onto the main unit and gently press
the lid downward. Be sure the nozzle is facing forward
when putting the lid back onto the main unit.
Plug in the Micro USB cable into the main unit and
plug in the other end of the cable to a USB port
（as shown in figure）.
• Please use an AC adapter that complies with the
safety regulations when using general household
outlets to supply power.
Press the lid downward to turn the power on. The lid
will rise upward when it starts to operate.
The spray setting button located at the bottom of the
main unit can be used to select the spray setting
（default setting is 3 minutes）.
• Blue light – 3 minutes spray setting.
Yellow light – 5 minutes spray setting.
• Operating 8 hours a day:
Provides approximately 30 days of continuous use
when set at 3 minute intervals.
Provides approximately 60 days of continuous use
when set at a 5 minute intervals.
• Usage days dependent upon spray setting and
Fragrance Aqua used.
Cleaning & Maintenance
• Always remove the power cable before cleaning & maintenance.
• It is recommended to clean and maintain the unit as soon as the Fragrance Aqua is depleted in order to
ensure proper operation of the machine.
1
Press the lid downward to turn off the power and
remove the Micro USB cable.
2
Press the lid downward and remove the lid once it is
raised upward for cleaning & maintenance.
Make sure the USB power cable is unplugged from
the main unit.
3
Open the rubber cap of the water tank underneath
the lid to empty the unused Fragrance Aqua left inside.
4
Clean the water tank with warm water（do not
exceed 40°C）, place the rubber cap back in place and
shake gently.
Open the rubber cap to empty the water in the water
tank（repeat a few times if required）.
5
1
2
To reuse, fill the water tank with SERENE HOUSE
Fragrance Aqua of your choice and close the rubber
cap.
Allow the water tank to dry thoroughly prior to
adding Fragrance Aqua.
6
Put the lid back onto the main unit and gently press the
lid downward.
Be sure the nozzle is facing forward when putting the
lid back onto the main unit.
7
Plug in the Micro USB cable into the main unit and plug
in the other end of the cable to a USB port（as shown
in figure）.
• Please use an AC adapter that complies with the
safety regulations when using general household
outlets to supply power.