Maruson MBS-610RM Quick Manual

Maintenance
Bypass Switch Module
Quick Guide

1. Introduction

The module is used as an external maintenance bypass switch to provide continuous
power without shutting down the connected loads during UPS scheduled maintenance
or battery replacement. It's perfect to use in conjunction with 6K/10K VA UPS.
Rack Mount the Unit
The module can be mounted to a 19" enclosure. Please follow below chart
for rack mount installation.

2. Product Overview

Diagram 1: Rear panel View

Input/Output terminal
(Refer to diagram 2 for the details)

UPS input breaker

Maintenance bypass switch

Control output signal slot


3. Installation and Operation

V. 1.1
Inspection
Unpack the package and check the package contents. The shipping package contains:
 Maintenance bypass switch module x 1
 Quick guide x 1
 Control signal cable x 1
NOTE: Before installation, please inspect the unit. Be sure that nothing inside the
package is damaged during transportation. Do not turn on the unit and notify the
carrier and dealer immediately if there is any damage or lacking of some parts.
Please keep the original package in a safe place for future use.
Initial Setup
The Installation and wiring must be performed in accordance with the local electric
laws/regulations and execute the following instructions by professional personnel.
1) Make sure the mains wire and breakers in the building are enough for the rated
capacity of UPS to avoid the hazards of electric shock or fire.
NOTE: Do not use the wall receptacle as the input power source for the UPS, as its
rated current is less than the UPS's maximum input current. Otherwise, the receptacle may be
burned and destroyed.
2) Switch off the mains switch in the building before installation.
3) Turn off and shut down the connected UPS.
Diagram 2: Terminal overview

Output terminal

UPS output terminal

UPS input terminal

Utility input terminal

Grounding terminal